Home › Refrigerator Water Filters › Whirlpool › WRF736SDAM13
Water Filter for the Whirlpool WRF736SDAM13 (EDR2RXD2)
✓ 100% compatible — no bypass plug needed
🔧 5-min push-in swap
🇺🇸 Ships from Indiana
Every cartridge that fits this model — pulled live from the catalogue:
✓
WRF736SDAM13 specifics — where the filter actually lives
Finding the bay is the easy part — this chassis puts it inside the fresh-food cavity, upper zone in most French-door builds, a spot that survives trim changes across the WRF run. The seat is a twist-in design — half a turn of wrist work in each direction is the whole procedure; everything else is towel management.
Two quirks worth knowing before you order: the line is still live when you open the bay, so keep a towel in reach, and expect the filter-status light to need a reset before it believes the new cartridge. WRF is not a trim code, it is a chassis statement: WRF is Whirlpool’s French-door bottom-freezer designation proper, and the service literature files every one of these under the same cartridge line. Suffix 13 = production revision; filtration hardware was not part of the revision cycle.
WRF vs WRS — what the prefix tells you
Two prefixes, two missions: WRF means French-door bottom-freezer, WRS means side-by-side. For filter shopping the distinction matters less than you would think — same line, different cabinet. Per the official efficiency listing, the WRF736SDAM13 spans 2012-2016 — the manufacturer-stated production window.
Swap it in 5 minutes
- Twist the old cartridge a quarter turn counterclockwise and pull it straight down — keep a towel in reach for the dribble.
- Fill the new cartridge with cold tap water so the chamber is not fighting an air pocket.
- Offer the new cartridge to the bay, push up, and twist a quarter turn clockwise until the stop catches.
- Run two gallons through the dispenser to flush carbon fines, then hold the filter-reset control until the status light clears.
What this filter takes out of your water
| What it targets | Standard that covers it |
|---|---|
| Chlorine taste & odor | NSF/ANSI 42 — aesthetic effects |
| Particulates, Class I | NSF/ANSI 42 — fine sediment |
| Lead | NSF/ANSI 53 — health effects |
| Cysts (cryptosporidium, giardia) | NSF/ANSI 53 — microbial |
| PFOA & PFOS | NSF/ANSI 53 (P473) — varies by cartridge |
Coverage above lists what the standard addresses, not a performance claim for any specific cartridge — removal claims vary by certificate, so check the NSF listing for the exact part number you are buying.
WRF736SDAM13 filter questions
Filter light reset on the Whirlpool WRF736SDAM13 — how?
With the new cartridge seated, press and hold the filter reset until the light clears — panel placement differs, so the WRF736SDAM13 manual’s filter section has the exact control for your trim.
Running the WRF736SDAM13 with an empty filter bay — does it need a cap?
The bay self-seals: with no cartridge the WRF736SDAM13 still dispenses, just unfiltered. No bypass plug exists for this line.
Are off-brand filters safe for a Whirlpool refrigerator?
Certified aftermarket cartridges are built to the same NSF test standards as the OEM part, and federal warranty law (Magnuson-Moss) protects your coverage when you use them.
Why is the OEM EDR2RXD2 cartridge so much more expensive?
Part of the OEM price is the badge and the distribution chain. Certified alternatives meet the same test standards at a lower unit price, especially in multi-packs.
How often should I replace the filter in my WRF736SDAM13?
Every six months or at the rated gallon capacity, whichever comes first — the EDR2RXD2 class cartridges all share that service interval.
Do I need to turn off the water supply to change it?
No — the bay is designed for a live swap. Expect a small dribble, keep a towel in reach, and flush a couple of gallons through the new cartridge before the first glass.
Every filter that fits your fridge
This bay takes the OEM EDR2RXD2. ClearFit verified-fit alternatives for this exact slot are being staged — every compatible option for your fridge is one lookup away.
Check every filter that fits →This filter expires six months from today
Your HVAC filter is probably on a different cycle. Track them all in one place.
months until this filter should be replaced (200-gal rated life)
Free tool · tracks fridge + HVAC + whole-house · auto-refill optional
More models using this filter
Related guides
POPULAR GUIDE
How to change a Whirlpool refrigerator water filter
Every Filter 1–6 bay location — including the door-mounted bays on WRX models, with door-open angles and cap-release quirks. — read the guide →
POPULAR GUIDE
How to reset your Whirlpool filter light
Filter 1–6 indicator maps showing which key actually clears the light on your panel. — read the guide →
WATER PROBLEM GUIDE
Does your fridge filter remove fluoride?
What EDR1RXD1-class carbon blocks actually take out — and the systems that do remove fluoride. — read the guide →