Water Filter for the Whirlpool TMH14XLB0 (EDR4RXD1)

Your Whirlpool refrigerator takes the EDR4RXD1 slot. Below is every filter that fits — OEM and certified alternatives — with real prices.

✓ 100% compatible — no bypass plug needed

🔧 5-min push-in swap

🇺🇸 Ships from Indiana

TMH14XLB0 · Quick Facts

TYPE

refrigerator

YEARS MADE

2013-2017

FILTER LOCATION

inside the fresh-food cavity, position varying with dispenser spec

FILTER SLOT

EveryDrop Filter 4 bay

REPLACE EVERY

Every 6 months

ALSO BRANDED AS

—

TMH14XLB0 · Quick Facts

Filter locationinside the fresh-food cavity, position varying with dispenser spec

Filter slotEveryDrop Filter 4 bay

Replace everyEvery 6 months

Years made2013-2017

Typical installTwist or push — 5 minutes, no tools

Every cartridge that fits this model — pulled live from the catalogue:

✓

Verified fit for TMH14XLB0. Cross-checked against Whirlpool service documentation — this model family uses the EDR4RXD1 bay with no chip or bypass restrictions.

Not your model? Check the finder →

TMH14XLB0 specifics — where the filter actually lives

Finding the bay is the easy part — this chassis puts it inside the fresh-food cavity, position varying with dispenser spec, so expect to clear one shelf edge before you have working room. Mechanically the TMH14XLB0 uses a twist-in cartridge: the bay wants the cartridge offered flat, rotated a quarter turn, and nothing more — hand pressure only.

Owners of the TMH14XLB0 report the same friction points: the reset control is the step everyone skips; the light will not acknowledge a new cartridge on its own. The constant across every trim of this machine is the cartridge line — the EDR4RXD1 media line; that is the anchor every compatible listing hangs from. That B0 suffix is trim-level shorthand. Whirlpool kept the EDR4RXD1 bay common to every finish in the line.

Reading the TMH14XLB0 model code — what the digits tell you

The TMH14XLB0 decodes to about 2013 to 2017 by catalog convention — close enough to bracket the cartridge generation, not close enough to certify. One generation, one cartridge: whatever the door count, the cartridge answer for this chassis is the EDR4RXD1 family.

Swap it in 5 minutes

Twist the old cartridge a quarter turn counterclockwise and pull it straight down — keep a towel in reach for the dribble.
Fill the new cartridge with cold tap water so the chamber is not fighting an air pocket.
Offer the new cartridge to the bay, push up, and twist a quarter turn clockwise until the stop catches.
Run two gallons through the dispenser to flush carbon fines, then hold the filter-reset control until the status light clears.

What this filter takes out of your water

What it targets	Standard that covers it
Chlorine taste & odor	NSF/ANSI 42 — aesthetic effects
Particulates, Class I	NSF/ANSI 42 — fine sediment
Lead	NSF/ANSI 53 — health effects
Cysts (cryptosporidium, giardia)	NSF/ANSI 53 — microbial
PFOA & PFOS	NSF/ANSI 53 (P473) — varies by cartridge

Coverage above lists what the standard addresses, not a performance claim for any specific cartridge — removal claims vary by certificate, so check the NSF listing for the exact part number you are buying.

TMH14XLB0 filter questions

How do I reset the filter light on the Whirlpool TMH14XLB0?

Hold the filter-reset control a few seconds after seating the new cartridge; placements vary by control panel, and the TMH14XLB0 manual’s filter-status page has the exact spot.

Whirlpool TMH14XLB0: bypass plug needed without a filter?

No bypass needed: the EDR4RXD1 bay closes on its own, and running empty simply means the water skips filtration until you seat a new cartridge.

Are off-brand filters safe for a Whirlpool refrigerator?

Certified aftermarket cartridges are built to the same NSF test standards as the OEM part, and federal warranty law (Magnuson-Moss) protects your coverage when you use them.

Why is the OEM EDR4RXD1 cartridge so much more expensive?

Part of the OEM price is the badge and the distribution chain. Certified alternatives meet the same test standards at a lower unit price, especially in multi-packs.

How often should I replace the filter in my TMH14XLB0?

Every six months or at the rated gallon capacity, whichever comes first — the EDR4RXD1 class cartridges all share that service interval.

Do I need to turn off the water supply to change it?

No — the bay is designed for a live swap. Expect a small dribble, keep a towel in reach, and flush a couple of gallons through the new cartridge before the first glass.

Every filter that fits your fridge

OEM EDR4RXD1 cartridge

This bay takes the OEM EDR4RXD1. ClearFit verified-fit alternatives for this exact slot are being staged — every compatible option for your fridge is one lookup away.

Check every filter that fits →