Home › Refrigerator Water Filters › Whirlpool › MSD2550VES02
Water Filter for the Maytag MSD2550VES02 (EDR3RXD1)
✓ 100% compatible — no bypass plug needed
🔧 5-min push-in swap
🇺🇸 Ships from Indiana
Every cartridge that fits this model — pulled live from the catalogue:
✓
MSD2550VES02 specifics — where the filter actually lives
Where the filter actually lives: behind the lower fresh-food trim or base grille in most side-by-side layouts, so expect to clear one shelf edge before you have working room. Mechanically it is a quarter-turn twist-in seat: a quarter turn one way to release, the other to seat, and the only tool you need is a towel for the drip.
The small print owners learn the hard way: plan on a towel for the first pull — sitting water in the line — and a five-second reset hold once the fresh cartridge is in. Decode the plate and the parts question answers itself: MSD on this badge family usually means side-by-side stock, which is why fit charts list cartridges by chassis code first. Suffix 02 = production revision; filtration hardware was not part of the revision cycle.
MSD vs MFI — what the prefix tells you
Prefix families here: MSD against MFI. side-by-side against French-door, respectively. Filter bays rarely care — the media family carries over more often than not. Model-code reading puts the MSD2550VES02 at roughly 2008 to 2012 — treat that as approximately right, not a production guarantee.
Swap it in 5 minutes
- Twist the old cartridge a quarter turn counterclockwise and pull it straight down — keep a towel in reach for the dribble.
- Fill the new cartridge with cold tap water so the chamber is not fighting an air pocket.
- Offer the new cartridge to the bay, push up, and twist a quarter turn clockwise until the stop catches.
- Run two gallons through the dispenser to flush carbon fines, then hold the filter-reset control until the status light clears.
What this filter takes out of your water
| What it targets | Standard that covers it |
|---|---|
| Chlorine taste & odor | NSF/ANSI 42 — aesthetic effects |
| Particulates, Class I | NSF/ANSI 42 — fine sediment |
| Lead | NSF/ANSI 53 — health effects |
| Cysts (cryptosporidium, giardia) | NSF/ANSI 53 — microbial |
| PFOA & PFOS | NSF/ANSI 53 (P473) — varies by cartridge |
Coverage above lists what the standard addresses, not a performance claim for any specific cartridge — removal claims vary by certificate, so check the NSF listing for the exact part number you are buying.
MSD2550VES02 filter questions
Reset procedure for the change-filter alert on the MSD2550VES02?
Hold the filter-reset control a few seconds after seating the new cartridge; placements vary by control panel, and the MSD2550VES02 manual’s filter-status page has the exact spot.
Will the Maytag MSD2550VES02 dispense water without a filter cartridge?
The bay self-seals: with no cartridge the MSD2550VES02 still dispenses, just unfiltered. No bypass plug exists for this line.
Are off-brand filters safe for a Maytag refrigerator?
Certified aftermarket cartridges are built to the same NSF test standards as the OEM part, and federal warranty law (Magnuson-Moss) protects your coverage when you use them.
Why is the OEM EDR3RXD1 cartridge so much more expensive?
Part of the OEM price is the badge and the distribution chain. Certified alternatives meet the same test standards at a lower unit price, especially in multi-packs.
How often should I replace the filter in my MSD2550VES02?
Every six months or at the rated gallon capacity, whichever comes first — the EDR3RXD1 class cartridges all share that service interval.
Do I need to turn off the water supply to change it?
No — the bay is designed for a live swap. Expect a small dribble, keep a towel in reach, and flush a couple of gallons through the new cartridge before the first glass.
Every filter that fits your fridge
This bay takes the OEM EDR3RXD1. ClearFit verified-fit alternatives for this exact slot are being staged — every compatible option for your fridge is one lookup away.
Check every filter that fits →This filter expires six months from today
Your HVAC filter is probably on a different cycle. Track them all in one place.
months until this filter should be replaced (200-gal rated life)
Free tool · tracks fridge + HVAC + whole-house · auto-refill optional
More models using this filter
Related guides
POPULAR GUIDE
How to change a Whirlpool refrigerator water filter
Every Filter 1–6 bay location — including the door-mounted bays on WRX models, with door-open angles and cap-release quirks. — read the guide →
POPULAR GUIDE
How to reset your Whirlpool filter light
Filter 1–6 indicator maps showing which key actually clears the light on your panel. — read the guide →
WATER PROBLEM GUIDE
Does your fridge filter remove fluoride?
What EDR1RXD1-class carbon blocks actually take out — and the systems that do remove fluoride. — read the guide →