MFI2568AEQ
Exact-Fit Model Guide

Water Filter for the Maytag MFI2568AEQ (EDR4RXD1)

Your Whirlpool refrigerator takes the EDR4RXD1 slot. Below is every filter that fits — OEM and certified alternatives — with real prices.

✓ 100% compatible — no bypass plug needed

🔧 5-min push-in swap

🇺🇸 Ships from Indiana

MFI2568AEQ replacement water filter cartridge
Replacement cartridge for this model
MFI2568AEQ · Quick Facts
TYPE
refrigerator
YEARS MADE
2012-2016
FILTER LOCATION
upper rear of the fresh-food section in most French-door builds with interior dispensers
FILTER SLOT
EveryDrop Filter 4 bay
REPLACE EVERY
Every 6 months
ALSO BRANDED AS
MFI2568AEQ · Quick Facts
Filter locationupper rear of the fresh-food section in most French-door builds with interior dispensers
Filter slotEveryDrop Filter 4 bay
Replace everyEvery 6 months
Years made2012-2016
Typical installTwist or push — 5 minutes, no tools

Every cartridge that fits this model — pulled live from the catalogue:

Verified fit for MFI2568AEQ. Cross-checked against Whirlpool service documentation — this model family uses the EDR4RXD1 bay with no chip or bypass restrictions.

MFI2568AEQ specifics — where the filter actually lives

The MFI2568AEQ carries its water filter upper rear of the fresh-food section in most French-door builds with interior dispensers, a deliberate placement that keeps the swap away from the door seals and drawer rails. The seat is a twist-in design — one twist to release, one to lock; between them you are holding the entire service procedure.

The recurring owner notes: the reset control is the step everyone skips; the light will not acknowledge a new cartridge on its own. One prefix, one chassis family: it usually places the machine in the French-door family, a strong hint at the cartridge line, the reset behavior, and the service documentation worth consulting. Finish letter sets like EQ never alter the bay; the EDR4RXD1 line fits the whole set.

MFI vs MSD — what the prefix tells you

Two prefixes, two missions: French-door builds carry MFI; side-by-side builds carry MSD. Filter-wise the two lines converge on one cartridge family. The MFI2568AEQ code suggests roughly 2012-2016 production — approximately right, which is all a parts search needs.

Swap it in 5 minutes

Installing the replacement water filter in the MFI2568AEQ
  • Twist the old cartridge a quarter turn counterclockwise and pull it straight down — keep a towel in reach for the dribble.
  • Fill the new cartridge with cold tap water so the chamber is not fighting an air pocket.
  • Offer the new cartridge to the bay, push up, and twist a quarter turn clockwise until the stop catches.
  • Run two gallons through the dispenser to flush carbon fines, then hold the filter-reset control until the status light clears.

What this filter takes out of your water

Old cartridge vs new — the difference a timely swap makes
What it targetsStandard that covers it
Chlorine taste & odorNSF/ANSI 42 — aesthetic effects
Particulates, Class INSF/ANSI 42 — fine sediment
LeadNSF/ANSI 53 — health effects
Cysts (cryptosporidium, giardia)NSF/ANSI 53 — microbial
PFOA & PFOSNSF/ANSI 53 (P473) — varies by cartridge

Coverage above lists what the standard addresses, not a performance claim for any specific cartridge — removal claims vary by certificate, so check the NSF listing for the exact part number you are buying.

MFI2568AEQ filter questions

MFI2568AEQ filter light will not turn off — what is the reset step?

Hold the filter-reset control a few seconds after the swap; the status light clears only with a seated cartridge, and the MFI2568AEQ manual maps the control by panel type.

Maytag MFI2568AEQ: bypass plug needed without a filter?

Nothing to buy — the EDR4RXD1 housing closes without a cartridge; water runs unfiltered until the next one goes in.

Are off-brand filters safe for a Maytag refrigerator?

Certified aftermarket cartridges are built to the same NSF test standards as the OEM part, and federal warranty law (Magnuson-Moss) protects your coverage when you use them.

Why is the OEM EDR4RXD1 cartridge so much more expensive?

Part of the OEM price is the badge and the distribution chain. Certified alternatives meet the same test standards at a lower unit price, especially in multi-packs.

How often should I replace the filter in my MFI2568AEQ?

Every six months or at the rated gallon capacity, whichever comes first — the EDR4RXD1 class cartridges all share that service interval.

Do I need to turn off the water supply to change it?

No — the bay is designed for a live swap. Expect a small dribble, keep a towel in reach, and flush a couple of gallons through the new cartridge before the first glass.

Every filter that fits your fridge

OEM EDR4RXD1 cartridge

This bay takes the OEM EDR4RXD1. ClearFit verified-fit alternatives for this exact slot are being staged — every compatible option for your fridge is one lookup away.

Check every filter that fits →

This filter expires six months from today

Your HVAC filter is probably on a different cycle. Track them all in one place.

6

months until this filter should be replaced (200-gal rated life)

Free tool · tracks fridge + HVAC + whole-house · auto-refill optional

More models using this filter

refrigerator
refrigerator
refrigerator
refrigerator

Related guides

POPULAR GUIDE

How to change a Whirlpool refrigerator water filter

Every Filter 1–6 bay location — including the door-mounted bays on WRX models, with door-open angles and cap-release quirks. — read the guide →

POPULAR GUIDE

How to reset your Whirlpool filter light

Filter 1–6 indicator maps showing which key actually clears the light on your panel. — read the guide →

WATER PROBLEM GUIDE

Does your fridge filter remove fluoride?

What EDR1RXD1-class carbon blocks actually take out — and the systems that do remove fluoride. — read the guide →