Home › Refrigerator Water Filters › Whirlpool › MFI2269VEW1
Water Filter for the Maytag MFI2269VEW1 (EDR4RXD1)
✓ 100% compatible — no bypass plug needed
🔧 5-min push-in swap
🇺🇸 Ships from Indiana
Every cartridge that fits this model — pulled live from the catalogue:
✓
MFI2269VEW1 specifics — where the filter actually lives
The filter bay on the MFI2269VEW1 upper rear of the fresh-food section in most French-door builds with interior dispensers — usually a kneeling-height or shoulder-height swap, not a teardown. The seat is a twist-in design — seat the cartridge against the o-ring, quarter-turn clockwise, and let the keyed flange do the aligning for you.
Two quirks worth knowing before you order: a stubborn first twist when the old o-ring has set, and a change-filter light that will not clear itself until you hold the reset. The badge reads MFI2269VEW1, but the chassis reads MFI: MFI on this badge family usually means French-door stock, which is why fit charts list cartridges by chassis code first. Trailing letters like W1 denote trim and finish: stainless, panel-ready, handle variants. The water path is identical across them.
MFI vs MSD — what the prefix tells you
The MFI/MSD pair divides this family by layout — MFI marks French-door builds and MSD marks side-by-side builds. Cross-checking the prefix before ordering is faster than returning the wrong cartridge. By model-code convention the MFI2269VEW1 falls around 2008 to 2012; treat the dates as a working estimate, not record.
Swap it in 5 minutes
- Twist the old cartridge a quarter turn counterclockwise and pull it straight down — keep a towel in reach for the dribble.
- Fill the new cartridge with cold tap water so the chamber is not fighting an air pocket.
- Offer the new cartridge to the bay, push up, and twist a quarter turn clockwise until the stop catches.
- Run two gallons through the dispenser to flush carbon fines, then hold the filter-reset control until the status light clears.
What this filter takes out of your water
| What it targets | Standard that covers it |
|---|---|
| Chlorine taste & odor | NSF/ANSI 42 — aesthetic effects |
| Particulates, Class I | NSF/ANSI 42 — fine sediment |
| Lead | NSF/ANSI 53 — health effects |
| Cysts (cryptosporidium, giardia) | NSF/ANSI 53 — microbial |
| PFOA & PFOS | NSF/ANSI 53 (P473) — varies by cartridge |
Coverage above lists what the standard addresses, not a performance claim for any specific cartridge — removal claims vary by certificate, so check the NSF listing for the exact part number you are buying.
MFI2269VEW1 filter questions
Maytag MFI2269VEW1: how do I clear the change-filter light?
Hold the filter-reset control a few seconds after seating the new cartridge; placements vary by control panel, and the MFI2269VEW1 manual’s filter-status page has the exact spot.
Running the MFI2269VEW1 with an empty filter bay — does it need a cap?
No bypass needed: the EDR4RXD1 bay closes on its own, and running empty simply means the water skips filtration until you seat a new cartridge.
Are off-brand filters safe for a Maytag refrigerator?
Certified aftermarket cartridges are built to the same NSF test standards as the OEM part, and federal warranty law (Magnuson-Moss) protects your coverage when you use them.
Why is the OEM EDR4RXD1 cartridge so much more expensive?
Part of the OEM price is the badge and the distribution chain. Certified alternatives meet the same test standards at a lower unit price, especially in multi-packs.
How often should I replace the filter in my MFI2269VEW1?
Every six months or at the rated gallon capacity, whichever comes first — the EDR4RXD1 class cartridges all share that service interval.
Do I need to turn off the water supply to change it?
No — the bay is designed for a live swap. Expect a small dribble, keep a towel in reach, and flush a couple of gallons through the new cartridge before the first glass.
Every filter that fits your fridge
| Cartridge | OEM EDR4RXD1 | RECOMMENDEDUKF8001 Replacement Water Filter · 1-Pack – ClearFit | EDR4RXD1 EveryDrop Filter 4 Replacement · 1-Pack – ClearFit | UKF8001 Replacement Water Filter · 3-Pack – ClearFit |
|---|---|---|---|---|
| Price | OEM list | $17.99 | $17.99 | $44.97 |
| Verified fit | ✓ the bay cartridge | View & buy → | View & buy → | View & buy → |
This filter expires six months from today
Your HVAC filter is probably on a different cycle. Track them all in one place.
months until this filter should be replaced (200-gal rated life)
Free tool · tracks fridge + HVAC + whole-house · auto-refill optional
More models using this filter
Related guides
POPULAR GUIDE
How to change a Whirlpool refrigerator water filter
Every Filter 1–6 bay location — including the door-mounted bays on WRX models, with door-open angles and cap-release quirks. — read the guide →
POPULAR GUIDE
How to reset your Whirlpool filter light
Filter 1–6 indicator maps showing which key actually clears the light on your panel. — read the guide →
WATER PROBLEM GUIDE
Does your fridge filter remove fluoride?
What EDR1RXD1-class carbon blocks actually take out — and the systems that do remove fluoride. — read the guide →