Water Filter for the Maytag MFD2562VE (EDR4RXD1)

Your Whirlpool refrigerator takes the EDR4RXD1 slot. Below is every filter that fits — OEM and certified alternatives — with real prices.

✓ 100% compatible — no bypass plug needed

🔧 5-min push-in swap

🇺🇸 Ships from Indiana

MFD2562VE · Quick Facts

TYPE

refrigerator

YEARS MADE

2008-2012

FILTER LOCATION

in the fresh-food compartment — exact spot varies by dispenser layout

FILTER SLOT

EveryDrop Filter 4 bay

REPLACE EVERY

Every 6 months

ALSO BRANDED AS

—

MFD2562VE · Quick Facts

Filter locationin the fresh-food compartment — exact spot varies by dispenser layout

Filter slotEveryDrop Filter 4 bay

Replace everyEvery 6 months

Years made2008-2012

Typical installTwist or push — 5 minutes, no tools

Every cartridge that fits this model — pulled live from the catalogue:

✓

Verified fit for MFD2562VE. Cross-checked against Whirlpool service documentation — this model family uses the EDR4RXD1 bay with no chip or bypass restrictions.

Not your model? Check the finder →

MFD2562VE specifics — where the filter actually lives

On the MFD2562VE, the cartridge in the fresh-food compartment — exact spot varies by dispenser layout — usually a kneeling-height or shoulder-height swap, not a teardown. It is a twist-lock bay: look for the index lugs, offer the cartridge, and rotate until they disappear into the housing.

Two quirks worth knowing before you order: expect the first swap to take longer than the box suggests — aged o-rings grip — so budget ten minutes, not five. What pins the parts choice down is the media line: the EDR4RXD1 cartridge family is what every fit listing for this chassis resolves to, OEM and certified alternative alike. The VE tail marks finish variants of one chassis; the filter bay is shared across the entire finish range.

Reading the MFD2562VE model code — what the digits tell you

The MFD2562VE decodes to about 2008-2012 by catalog convention — close enough to bracket the cartridge generation, not close enough to certify. Fit listings tell the same story: the EDR4RXD1 cartridge is the one constant across the model run.

Swap it in 5 minutes

Twist the old cartridge a quarter turn counterclockwise and pull it straight down — keep a towel in reach for the dribble.
Fill the new cartridge with cold tap water so the chamber is not fighting an air pocket.
Offer the new cartridge to the bay, push up, and twist a quarter turn clockwise until the stop catches.
Run two gallons through the dispenser to flush carbon fines, then hold the filter-reset control until the status light clears.

What this filter takes out of your water

What it targets	Standard that covers it
Chlorine taste & odor	NSF/ANSI 42 — aesthetic effects
Particulates, Class I	NSF/ANSI 42 — fine sediment
Lead	NSF/ANSI 53 — health effects
Cysts (cryptosporidium, giardia)	NSF/ANSI 53 — microbial
PFOA & PFOS	NSF/ANSI 53 (P473) — varies by cartridge

Coverage above lists what the standard addresses, not a performance claim for any specific cartridge — removal claims vary by certificate, so check the NSF listing for the exact part number you are buying.

MFD2562VE filter questions

How do I reset the filter light on the Maytag MFD2562VE?

Press and hold the reset control until the light clears (a few seconds), with the new cartridge already seated — the MFD2562VE owner’s manual lists the button location for your control panel.

Maytag MFD2562VE: bypass plug needed without a filter?

No bypass needed: the EDR4RXD1 bay closes on its own, and running empty simply means the water skips filtration until you seat a new cartridge.

Are off-brand filters safe for a Maytag refrigerator?

Certified aftermarket cartridges are built to the same NSF test standards as the OEM part, and federal warranty law (Magnuson-Moss) protects your coverage when you use them.

Why is the OEM EDR4RXD1 cartridge so much more expensive?

Part of the OEM price is the badge and the distribution chain. Certified alternatives meet the same test standards at a lower unit price, especially in multi-packs.

How often should I replace the filter in my MFD2562VE?

Every six months or at the rated gallon capacity, whichever comes first — the EDR4RXD1 class cartridges all share that service interval.

Do I need to turn off the water supply to change it?

No — the bay is designed for a live swap. Expect a small dribble, keep a towel in reach, and flush a couple of gallons through the new cartridge before the first glass.

Every filter that fits your fridge

OEM EDR4RXD1 cartridge

This bay takes the OEM EDR4RXD1. ClearFit verified-fit alternatives for this exact slot are being staged — every compatible option for your fridge is one lookup away.

Check every filter that fits →