Home › Refrigerator Water Filters › Whirlpool › KSRT25CRWH00
Water Filter for the KitchenAid KSRT25CRWH00 (EDR3RXD1)
✓ 100% compatible — no bypass plug needed
🔧 5-min push-in swap
🇺🇸 Ships from Indiana
Every cartridge that fits this model — pulled live from the catalogue:
✓
KSRT25CRWH00 specifics — where the filter actually lives
Where the filter actually lives: low on the fresh-food side or behind the base grille in most side-by-side layouts — usually a kneeling-height or shoulder-height swap, not a teardown. Mechanically it is a quarter-turn twist-in seat: look for the index lugs, offer the cartridge, and rotate until they disappear into the housing.
Practical notes from the install forums: expect the first swap to take longer than the box suggests — aged o-rings grip — so budget ten minutes, not five. The KSR in KSRT25CRWH00 is doing real work: it usually places the machine in the side-by-side chassis family, a strong hint at the cartridge line, the reset behavior, and the service documentation worth consulting. Suffix 00 = production revision; filtration hardware was not part of the revision cycle.
KSR vs KTR — what the prefix tells you
The KSR/KTR pair divides this family by layout — Ordering by prefix works because KSR means side-by-side chassis and KTR means top-freezer in this catalog — and the cartridge pool overlaps both. Catalog convention puts the KSRT25CRWH00 near 2005-2009 — an approximation, useful for bracketing the cartridge era only.
Swap it in 5 minutes
- Twist the old cartridge a quarter turn counterclockwise and pull it straight down — keep a towel in reach for the dribble.
- Fill the new cartridge with cold tap water so the chamber is not fighting an air pocket.
- Offer the new cartridge to the bay, push up, and twist a quarter turn clockwise until the stop catches.
- Run two gallons through the dispenser to flush carbon fines, then hold the filter-reset control until the status light clears.
What this filter takes out of your water
| What it targets | Standard that covers it |
|---|---|
| Chlorine taste & odor | NSF/ANSI 42 — aesthetic effects |
| Particulates, Class I | NSF/ANSI 42 — fine sediment |
| Lead | NSF/ANSI 53 — health effects |
| Cysts (cryptosporidium, giardia) | NSF/ANSI 53 — microbial |
| PFOA & PFOS | NSF/ANSI 53 (P473) — varies by cartridge |
Coverage above lists what the standard addresses, not a performance claim for any specific cartridge — removal claims vary by certificate, so check the NSF listing for the exact part number you are buying.
KSRT25CRWH00 filter questions
Filter light reset on the KitchenAid KSRT25CRWH00 — how?
Hold the filter-reset control a few seconds after the swap; the status light clears only with a seated cartridge, and the KSRT25CRWH00 manual maps the control by panel type.
KSRT25CRWH00 with no water filter installed — safe, or does it need a bypass?
No — the EDR3RXD1 bay seals on the cartridge itself, so removing it just means unfiltered water until the next change, not a leak.
Are off-brand filters safe for a KitchenAid refrigerator?
Certified aftermarket cartridges are built to the same NSF test standards as the OEM part, and federal warranty law (Magnuson-Moss) protects your coverage when you use them.
Why is the OEM EDR3RXD1 cartridge so much more expensive?
Part of the OEM price is the badge and the distribution chain. Certified alternatives meet the same test standards at a lower unit price, especially in multi-packs.
How often should I replace the filter in my KSRT25CRWH00?
Every six months or at the rated gallon capacity, whichever comes first — the EDR3RXD1 class cartridges all share that service interval.
Do I need to turn off the water supply to change it?
No — the bay is designed for a live swap. Expect a small dribble, keep a towel in reach, and flush a couple of gallons through the new cartridge before the first glass.
Every filter that fits your fridge
| Cartridge | OEM EDR3RXD1 | RECOMMENDEDEDR3RXD1 Replacement Water Filter · 1-Pack – ClearFit | EDR3RXD1 Replacement Water Filter · 3-Pack – ClearFit | EDR3RXD1 Replacement Water Filter · 6-Pack – ClearFit |
|---|---|---|---|---|
| Price | OEM list | $17.99 | $44.97 | $80.94 |
| Verified fit | ✓ the bay cartridge | View & buy → | View & buy → | View & buy → |
This filter expires six months from today
Your HVAC filter is probably on a different cycle. Track them all in one place.
months until this filter should be replaced (200-gal rated life)
Free tool · tracks fridge + HVAC + whole-house · auto-refill optional
More models using this filter
Related guides
POPULAR GUIDE
How to change a Whirlpool refrigerator water filter
Every Filter 1–6 bay location — including the door-mounted bays on WRX models, with door-open angles and cap-release quirks. — read the guide →
POPULAR GUIDE
How to reset your Whirlpool filter light
Filter 1–6 indicator maps showing which key actually clears the light on your panel. — read the guide →
WATER PROBLEM GUIDE
Does your fridge filter remove fluoride?
What EDR1RXD1-class carbon blocks actually take out — and the systems that do remove fluoride. — read the guide →