Home › Refrigerator Water Filters › Whirlpool › KSRS27ILWH00
Water Filter for the KitchenAid KSRS27ILWH00 (EDR5RXD1)
✓ 100% compatible — no bypass plug needed
🔧 5-min push-in swap
🇺🇸 Ships from Indiana
Every cartridge that fits this model — pulled live from the catalogue:
✓
KSRS27ILWH00 specifics — where the filter actually lives
The KSRS27ILWH00 carries its water filter low on the fresh-food side or behind the base grille in most side-by-side layouts — usually a kneeling-height or shoulder-height swap, not a teardown. Mechanically the KSRS27ILWH00 uses a twist-in cartridge: the cartridge drops into the keyed seat and locks with a short quarter turn.
Owners of the KSRS27ILWH00 report the same friction points: a first removal that fights a set o-ring, and a status light that needs a manual hold-to-reset before it acknowledges the new cartridge. The KSR in KSRS27ILWH00 is doing real work: KSR on this badge family usually means side-by-side chassis stock, which is why fit charts list cartridges by chassis code first. Read the 00 ending as a revision marker — KitchenAid used it for running changes, none of which touched the EDR5RXD1 bay.
KSR vs KTR — what the prefix tells you
Same parts shelf, two cabinet missions — The side-by-side chassis/top-freezer split tracks the KSR/KTR prefixes — cartridge fit follows the water path, not the label on the door. Working from the model code, the KSRS27ILWH00 lands somewhere around 2002 to 2006; treat the window as approximate.
Swap it in 5 minutes
- Twist the old cartridge a quarter turn counterclockwise and pull it straight down — keep a towel in reach for the dribble.
- Fill the new cartridge with cold tap water so the chamber is not fighting an air pocket.
- Offer the new cartridge to the bay, push up, and twist a quarter turn clockwise until the stop catches.
- Run two gallons through the dispenser to flush carbon fines, then hold the filter-reset control until the status light clears.
What this filter takes out of your water
| What it targets | Standard that covers it |
|---|---|
| Chlorine taste & odor | NSF/ANSI 42 — aesthetic effects |
| Particulates, Class I | NSF/ANSI 42 — fine sediment |
| Lead | NSF/ANSI 53 — health effects |
| Cysts (cryptosporidium, giardia) | NSF/ANSI 53 — microbial |
| PFOA & PFOS | NSF/ANSI 53 (P473) — varies by cartridge |
Coverage above lists what the standard addresses, not a performance claim for any specific cartridge — removal claims vary by certificate, so check the NSF listing for the exact part number you are buying.
KSRS27ILWH00 filter questions
Reset procedure for the change-filter alert on the KSRS27ILWH00?
Hold the filter-reset control a few seconds after the swap; the status light clears only with a seated cartridge, and the KSRS27ILWH00 manual maps the control by panel type.
Will the KitchenAid KSRS27ILWH00 dispense water without a filter cartridge?
Nothing to buy — the EDR5RXD1 housing closes without a cartridge; water runs unfiltered until the next one goes in.
Are off-brand filters safe for a KitchenAid refrigerator?
Certified aftermarket cartridges are built to the same NSF test standards as the OEM part, and federal warranty law (Magnuson-Moss) protects your coverage when you use them.
Why is the OEM EDR5RXD1 cartridge so much more expensive?
Part of the OEM price is the badge and the distribution chain. Certified alternatives meet the same test standards at a lower unit price, especially in multi-packs.
How often should I replace the filter in my KSRS27ILWH00?
Every six months or at the rated gallon capacity, whichever comes first — the EDR5RXD1 class cartridges all share that service interval.
Do I need to turn off the water supply to change it?
No — the bay is designed for a live swap. Expect a small dribble, keep a towel in reach, and flush a couple of gallons through the new cartridge before the first glass.
Every filter that fits your fridge
This bay takes the OEM EDR5RXD1. ClearFit verified-fit alternatives for this exact slot are being staged — every compatible option for your fridge is one lookup away.
Check every filter that fits →This filter expires six months from today
Your HVAC filter is probably on a different cycle. Track them all in one place.
months until this filter should be replaced (200-gal rated life)
Free tool · tracks fridge + HVAC + whole-house · auto-refill optional
More models using this filter
Related guides
POPULAR GUIDE
How to change a Whirlpool refrigerator water filter
Every Filter 1–6 bay location — including the door-mounted bays on WRX models, with door-open angles and cap-release quirks. — read the guide →
POPULAR GUIDE
How to reset your Whirlpool filter light
Filter 1–6 indicator maps showing which key actually clears the light on your panel. — read the guide →
WATER PROBLEM GUIDE
Does your fridge filter remove fluoride?
What EDR1RXD1-class carbon blocks actually take out — and the systems that do remove fluoride. — read the guide →