Home › Refrigerator Water Filters › Whirlpool › KSRB27FHSS00
Water Filter for the KitchenAid KSRB27FHSS00 (EDR5RXD1)
✓ 100% compatible — no bypass plug needed
🔧 5-min push-in swap
🇺🇸 Ships from Indiana
Every cartridge that fits this model — pulled live from the catalogue:
✓
KSRB27FHSS00 specifics — where the filter actually lives
The filter bay on the KSRB27FHSS00 low on the fresh-food side or behind the base grille in most side-by-side layouts, a spot that survives trim changes across the KSR run. Mechanically the KSRB27FHSS00 uses a twist-in cartridge: a quarter turn one way to release, the other to seat, and the only tool you need is a towel for the drip.
The recurring owner notes: flush before the first glass — new carbon beds shed fines for the first gallon or so, which is cosmetic, not contamination. The KSR prefix is the tell: count on KSR to place this unit among side-by-side chassis builds; that placement carries the water-path geometry with it. Revision 00 changed trim details, not the water circuit; order with confidence by model stem.
KSR vs KTR — what the prefix tells you
The KSR prefix sits next to KTR in the catalog and the split is cabinet mission: side-by-side chassis against top-freezer, respectively. Filter bays rarely care — the media family carries over more often than not. Model-code reading puts the KSRB27FHSS00 at roughly 2018-2022 — treat that as approximately right, not a production guarantee.
Swap it in 5 minutes
- Twist the old cartridge a quarter turn counterclockwise and pull it straight down — keep a towel in reach for the dribble.
- Fill the new cartridge with cold tap water so the chamber is not fighting an air pocket.
- Offer the new cartridge to the bay, push up, and twist a quarter turn clockwise until the stop catches.
- Run two gallons through the dispenser to flush carbon fines, then hold the filter-reset control until the status light clears.
What this filter takes out of your water
| What it targets | Standard that covers it |
|---|---|
| Chlorine taste & odor | NSF/ANSI 42 — aesthetic effects |
| Particulates, Class I | NSF/ANSI 42 — fine sediment |
| Lead | NSF/ANSI 53 — health effects |
| Cysts (cryptosporidium, giardia) | NSF/ANSI 53 — microbial |
| PFOA & PFOS | NSF/ANSI 53 (P473) — varies by cartridge |
Coverage above lists what the standard addresses, not a performance claim for any specific cartridge — removal claims vary by certificate, so check the NSF listing for the exact part number you are buying.
KSRB27FHSS00 filter questions
KSRB27FHSS00 filter light will not turn off — what is the reset step?
Press and hold the reset control until the light clears (a few seconds), with the new cartridge already seated — the KSRB27FHSS00 owner’s manual lists the button location for your control panel.
Can I run the KitchenAid KSRB27FHSS00 with no cartridge installed?
You can, but unfiltered — the EDR5RXD1 bay needs no bypass plug; it just passes water through without filtering while the cartridge is out.
Are off-brand filters safe for a KitchenAid refrigerator?
Certified aftermarket cartridges are built to the same NSF test standards as the OEM part, and federal warranty law (Magnuson-Moss) protects your coverage when you use them.
Why is the OEM EDR5RXD1 cartridge so much more expensive?
Part of the OEM price is the badge and the distribution chain. Certified alternatives meet the same test standards at a lower unit price, especially in multi-packs.
How often should I replace the filter in my KSRB27FHSS00?
Every six months or at the rated gallon capacity, whichever comes first — the EDR5RXD1 class cartridges all share that service interval.
Do I need to turn off the water supply to change it?
No — the bay is designed for a live swap. Expect a small dribble, keep a towel in reach, and flush a couple of gallons through the new cartridge before the first glass.
Every filter that fits your fridge
This bay takes the OEM EDR5RXD1. ClearFit verified-fit alternatives for this exact slot are being staged — every compatible option for your fridge is one lookup away.
Check every filter that fits →This filter expires six months from today
Your HVAC filter is probably on a different cycle. Track them all in one place.
months until this filter should be replaced (200-gal rated life)
Free tool · tracks fridge + HVAC + whole-house · auto-refill optional
More models using this filter
Related guides
POPULAR GUIDE
How to change a Whirlpool refrigerator water filter
Every Filter 1–6 bay location — including the door-mounted bays on WRX models, with door-open angles and cap-release quirks. — read the guide →
POPULAR GUIDE
How to reset your Whirlpool filter light
Filter 1–6 indicator maps showing which key actually clears the light on your panel. — read the guide →
WATER PROBLEM GUIDE
Does your fridge filter remove fluoride?
What EDR1RXD1-class carbon blocks actually take out — and the systems that do remove fluoride. — read the guide →