Home › Refrigerator Water Filters › Whirlpool › KFCO22EVBL1
Water Filter for the KitchenAid KFCO22EVBL1 (EDR4RXD1)
✓ 100% compatible — no bypass plug needed
🔧 5-min push-in swap
🇺🇸 Ships from Indiana
Every cartridge that fits this model — pulled live from the catalogue:
✓
KFCO22EVBL1 specifics — where the filter actually lives
Where the filter actually lives: in the fresh-food compartment, placement dependent on the dispenser package, so expect to clear one shelf edge before you have working room. Mechanically the KFCO22EVBL1 uses a twist-in cartridge: release is counterclockwise, seating is clockwise, and the stops are firm enough that you cannot overshoot.
The recurring owner notes: the line is still live when you open the bay, so keep a towel in reach, and expect the filter-status light to need a reset before it believes the new cartridge. Whatever the badge on the door says, the parts reality is the EDR4RXD1 cartridge family is what every fit listing for this chassis resolves to, OEM and certified alternative alike. The L1 ending is a finish code — color and handle options, not mechanical ones. Every finish of this chassis takes the same cartridge.
Reading the KFCO22EVBL1 model code — what the digits tell you
The KFCO22EVBL1 code suggests roughly 2008 to 2012 production — approximately right, which is all a parts search needs. What stays constant across the trim range: model-code suffixes track cosmetics; the EDR4RXD1 fit is invariant across them.
Swap it in 5 minutes
- Twist the old cartridge a quarter turn counterclockwise and pull it straight down — keep a towel in reach for the dribble.
- Fill the new cartridge with cold tap water so the chamber is not fighting an air pocket.
- Offer the new cartridge to the bay, push up, and twist a quarter turn clockwise until the stop catches.
- Run two gallons through the dispenser to flush carbon fines, then hold the filter-reset control until the status light clears.
What this filter takes out of your water
| What it targets | Standard that covers it |
|---|---|
| Chlorine taste & odor | NSF/ANSI 42 — aesthetic effects |
| Particulates, Class I | NSF/ANSI 42 — fine sediment |
| Lead | NSF/ANSI 53 — health effects |
| Cysts (cryptosporidium, giardia) | NSF/ANSI 53 — microbial |
| PFOA & PFOS | NSF/ANSI 53 (P473) — varies by cartridge |
Coverage above lists what the standard addresses, not a performance claim for any specific cartridge — removal claims vary by certificate, so check the NSF listing for the exact part number you are buying.
KFCO22EVBL1 filter questions
How do I reset the filter light on the KitchenAid KFCO22EVBL1?
Seat the new cartridge first, then hold the filter-reset control for a few seconds until the status light clears — the exact button placement varies by control panel, so check the KFCO22EVBL1 owner’s manual page for filter status.
Will the KitchenAid KFCO22EVBL1 dispense water without a filter cartridge?
Nothing to buy — the EDR4RXD1 housing closes without a cartridge; water runs unfiltered until the next one goes in.
Are off-brand filters safe for a KitchenAid refrigerator?
Certified aftermarket cartridges are built to the same NSF test standards as the OEM part, and federal warranty law (Magnuson-Moss) protects your coverage when you use them.
Why is the OEM EDR4RXD1 cartridge so much more expensive?
Part of the OEM price is the badge and the distribution chain. Certified alternatives meet the same test standards at a lower unit price, especially in multi-packs.
How often should I replace the filter in my KFCO22EVBL1?
Every six months or at the rated gallon capacity, whichever comes first — the EDR4RXD1 class cartridges all share that service interval.
Do I need to turn off the water supply to change it?
No — the bay is designed for a live swap. Expect a small dribble, keep a towel in reach, and flush a couple of gallons through the new cartridge before the first glass.
Every filter that fits your fridge
| Cartridge | OEM EDR4RXD1 | RECOMMENDEDUKF8001 Replacement Water Filter · 1-Pack – ClearFit | EDR4RXD1 EveryDrop Filter 4 Replacement · 1-Pack – ClearFit | UKF8001 Replacement Water Filter · 3-Pack – ClearFit |
|---|---|---|---|---|
| Price | OEM list | $17.99 | $17.99 | $44.97 |
| Verified fit | ✓ the bay cartridge | View & buy → | View & buy → | View & buy → |
This filter expires six months from today
Your HVAC filter is probably on a different cycle. Track them all in one place.
months until this filter should be replaced (200-gal rated life)
Free tool · tracks fridge + HVAC + whole-house · auto-refill optional
More models using this filter
Related guides
POPULAR GUIDE
How to change a Whirlpool refrigerator water filter
Every Filter 1–6 bay location — including the door-mounted bays on WRX models, with door-open angles and cap-release quirks. — read the guide →
POPULAR GUIDE
How to reset your Whirlpool filter light
Filter 1–6 indicator maps showing which key actually clears the light on your panel. — read the guide →
WATER PROBLEM GUIDE
Does your fridge filter remove fluoride?
What EDR1RXD1-class carbon blocks actually take out — and the systems that do remove fluoride. — read the guide →