Home › Refrigerator Water Filters › Whirlpool › KBRS22EVBL00
Water Filter for the KitchenAid KBRS22EVBL00 (EDR4RXD1)
✓ 100% compatible — no bypass plug needed
🔧 5-min push-in swap
🇺🇸 Ships from Indiana
Every cartridge that fits this model — pulled live from the catalogue:
✓
KBRS22EVBL00 specifics — where the filter actually lives
Where the filter actually lives: in the lower fresh-food zone in most side-by-side layouts, knee height or below, a deliberate placement that keeps the swap away from the door seals and drawer rails. Mechanically the KBRS22EVBL00 uses a twist-in cartridge: release is counterclockwise, seating is clockwise, and the stops are firm enough that you cannot overshoot.
Order-day practicalities: carbon fines in the first pours are normal for a fresh bed, and the filter timer only restarts when you hold the reset. One prefix, one chassis family: KBR typically codes for side-by-side variant machines in this catalog, and in that format the water path is long enough that a neglected cartridge shows up as flow drop before it shows up as taste. The -00 tail tracks the revision ladder — each rung shares the identical EDR4RXD1 bay.
KBR vs KSR — what the prefix tells you
Know your KBR from your KSR and the cartridge question halves: Ordering by prefix works because KBR means side-by-side variant and KSR means side-by-side chassis in this catalog — and the cartridge pool overlaps both. Model-code reading puts the KBRS22EVBL00 at roughly 2008 to 2012 — treat that as approximately right, not a production guarantee.
Swap it in 5 minutes
- Twist the old cartridge a quarter turn counterclockwise and pull it straight down — keep a towel in reach for the dribble.
- Fill the new cartridge with cold tap water so the chamber is not fighting an air pocket.
- Offer the new cartridge to the bay, push up, and twist a quarter turn clockwise until the stop catches.
- Run two gallons through the dispenser to flush carbon fines, then hold the filter-reset control until the status light clears.
What this filter takes out of your water
| What it targets | Standard that covers it |
|---|---|
| Chlorine taste & odor | NSF/ANSI 42 — aesthetic effects |
| Particulates, Class I | NSF/ANSI 42 — fine sediment |
| Lead | NSF/ANSI 53 — health effects |
| Cysts (cryptosporidium, giardia) | NSF/ANSI 53 — microbial |
| PFOA & PFOS | NSF/ANSI 53 (P473) — varies by cartridge |
Coverage above lists what the standard addresses, not a performance claim for any specific cartridge — removal claims vary by certificate, so check the NSF listing for the exact part number you are buying.
KBRS22EVBL00 filter questions
KBRS22EVBL00 filter light will not turn off — what is the reset step?
With the new cartridge seated, press and hold the filter reset until the light clears — panel placement differs, so the KBRS22EVBL00 manual’s filter section has the exact control for your trim.
Can I run the KitchenAid KBRS22EVBL00 with no cartridge installed?
No cap needed — the EDR4RXD1 bay passes water unfiltered while empty; it does not leak, it just skips filtration.
Are off-brand filters safe for a KitchenAid refrigerator?
Certified aftermarket cartridges are built to the same NSF test standards as the OEM part, and federal warranty law (Magnuson-Moss) protects your coverage when you use them.
Why is the OEM EDR4RXD1 cartridge so much more expensive?
Part of the OEM price is the badge and the distribution chain. Certified alternatives meet the same test standards at a lower unit price, especially in multi-packs.
How often should I replace the filter in my KBRS22EVBL00?
Every six months or at the rated gallon capacity, whichever comes first — the EDR4RXD1 class cartridges all share that service interval.
Do I need to turn off the water supply to change it?
No — the bay is designed for a live swap. Expect a small dribble, keep a towel in reach, and flush a couple of gallons through the new cartridge before the first glass.
Every filter that fits your fridge
| Cartridge | OEM EDR4RXD1 | RECOMMENDEDUKF8001 Replacement Water Filter · 1-Pack – ClearFit | EDR4RXD1 EveryDrop Filter 4 Replacement · 1-Pack – ClearFit | UKF8001 Replacement Water Filter · 3-Pack – ClearFit |
|---|---|---|---|---|
| Price | OEM list | $17.99 | $17.99 | $44.97 |
| Verified fit | ✓ the bay cartridge | View & buy → | View & buy → | View & buy → |
This filter expires six months from today
Your HVAC filter is probably on a different cycle. Track them all in one place.
months until this filter should be replaced (200-gal rated life)
Free tool · tracks fridge + HVAC + whole-house · auto-refill optional
More models using this filter
Related guides
POPULAR GUIDE
How to change a Whirlpool refrigerator water filter
Every Filter 1–6 bay location — including the door-mounted bays on WRX models, with door-open angles and cap-release quirks. — read the guide →
POPULAR GUIDE
How to reset your Whirlpool filter light
Filter 1–6 indicator maps showing which key actually clears the light on your panel. — read the guide →
WATER PROBLEM GUIDE
Does your fridge filter remove fluoride?
What EDR1RXD1-class carbon blocks actually take out — and the systems that do remove fluoride. — read the guide →