Home › Refrigerator Water Filters › Whirlpool › KBFS25EVMS00
Water Filter for the KitchenAid KBFS25EVMS00 (EDR4RXD1)
✓ 100% compatible — no bypass plug needed
🔧 5-min push-in swap
🇺🇸 Ships from Indiana
Every cartridge that fits this model — pulled live from the catalogue:
✓
KBFS25EVMS00 specifics — where the filter actually lives
Finding the bay is the easy part — this chassis puts it in the upper zone of the fresh-food compartment in most bottom-freezer layouts, so expect to clear one shelf edge before you have working room. Mechanically it is a quarter-turn twist-in seat: no tools, no housing removal, and the cartridge indexes in only one orientation despite looking symmetric.
Order-day practicalities: the change light ignores the new cartridge until you reset it, and the first removal always takes more muscle than the manual implies. The KBF prefix is the tell: the KBF tag is how the catalog sorts bottom-freezer machines — carry it into any fit checker and the right cartridge line follows. The two-digit 00 tail is revision bookkeeping. Badge position and shelf trim moved around; the bay geometry did not.
KBF vs KFI — what the prefix tells you
The KBF prefix sits next to KFI in the catalog and the split is cabinet mission: bottom-freezer on the KBF side, French-door on the KFI side — the parts catalog runs the same cartridge across both. The KBFS25EVMS00 decodes to about 2008-2012 by catalog convention — close enough to bracket the cartridge generation, not close enough to certify.
Swap it in 5 minutes
- Twist the old cartridge a quarter turn counterclockwise and pull it straight down — keep a towel in reach for the dribble.
- Fill the new cartridge with cold tap water so the chamber is not fighting an air pocket.
- Offer the new cartridge to the bay, push up, and twist a quarter turn clockwise until the stop catches.
- Run two gallons through the dispenser to flush carbon fines, then hold the filter-reset control until the status light clears.
What this filter takes out of your water
| What it targets | Standard that covers it |
|---|---|
| Chlorine taste & odor | NSF/ANSI 42 — aesthetic effects |
| Particulates, Class I | NSF/ANSI 42 — fine sediment |
| Lead | NSF/ANSI 53 — health effects |
| Cysts (cryptosporidium, giardia) | NSF/ANSI 53 — microbial |
| PFOA & PFOS | NSF/ANSI 53 (P473) — varies by cartridge |
Coverage above lists what the standard addresses, not a performance claim for any specific cartridge — removal claims vary by certificate, so check the NSF listing for the exact part number you are buying.
KBFS25EVMS00 filter questions
KBFS25EVMS00 filter light will not turn off — what is the reset step?
Hold the filter-reset control a few seconds after the swap; the status light clears only with a seated cartridge, and the KBFS25EVMS00 manual maps the control by panel type.
Running the KBFS25EVMS00 with an empty filter bay — does it need a cap?
Nothing to buy — the EDR4RXD1 housing closes without a cartridge; water runs unfiltered until the next one goes in.
Are off-brand filters safe for a KitchenAid refrigerator?
Certified aftermarket cartridges are built to the same NSF test standards as the OEM part, and federal warranty law (Magnuson-Moss) protects your coverage when you use them.
Why is the OEM EDR4RXD1 cartridge so much more expensive?
Part of the OEM price is the badge and the distribution chain. Certified alternatives meet the same test standards at a lower unit price, especially in multi-packs.
How often should I replace the filter in my KBFS25EVMS00?
Every six months or at the rated gallon capacity, whichever comes first — the EDR4RXD1 class cartridges all share that service interval.
Do I need to turn off the water supply to change it?
No — the bay is designed for a live swap. Expect a small dribble, keep a towel in reach, and flush a couple of gallons through the new cartridge before the first glass.
Every filter that fits your fridge
| Cartridge | OEM EDR4RXD1 | RECOMMENDEDUKF8001 Replacement Water Filter · 1-Pack – ClearFit | EDR4RXD1 EveryDrop Filter 4 Replacement · 1-Pack – ClearFit | UKF8001 Replacement Water Filter · 3-Pack – ClearFit |
|---|---|---|---|---|
| Price | OEM list | $17.99 | $17.99 | $44.97 |
| Verified fit | ✓ the bay cartridge | View & buy → | View & buy → | View & buy → |
This filter expires six months from today
Your HVAC filter is probably on a different cycle. Track them all in one place.
months until this filter should be replaced (200-gal rated life)
Free tool · tracks fridge + HVAC + whole-house · auto-refill optional
More models using this filter
Related guides
POPULAR GUIDE
How to change a Whirlpool refrigerator water filter
Every Filter 1–6 bay location — including the door-mounted bays on WRX models, with door-open angles and cap-release quirks. — read the guide →
POPULAR GUIDE
How to reset your Whirlpool filter light
Filter 1–6 indicator maps showing which key actually clears the light on your panel. — read the guide →
WATER PROBLEM GUIDE
Does your fridge filter remove fluoride?
What EDR1RXD1-class carbon blocks actually take out — and the systems that do remove fluoride. — read the guide →