Home › Refrigerator Water Filters › Whirlpool › GT1SHWXPT02
Water Filter for the Whirlpool GT1SHWXPT02 (EDR6D1)
✓ 100% compatible — no bypass plug needed
🔧 5-min push-in swap
🇺🇸 Ships from Indiana
Every cartridge that fits this model — pulled live from the catalogue:
✓
GT1SHWXPT02 specifics — where the filter actually lives
The filter bay on the GT1SHWXPT02 in the fresh-food compartment, placement dependent on the dispenser package — usually a kneeling-height or shoulder-height swap, not a teardown. The seat is a twist-in design — no tools, no housing removal, and the cartridge indexes in only one orientation despite looking symmetric.
Owners of the GT1SHWXPT02 report the same friction points: the change light ignores the new cartridge until you reset it, and the first removal always takes more muscle than the manual implies. Whatever the badge on the door says, the parts reality is this chassis drinks from the EDR6D1 family, one of the most cross-referenced cartridges in the Whirlpool catalog. Revision 02 changed trim details, not the water circuit; order with confidence by model stem.
Reading the GT1SHWXPT02 model code — what the digits tell you
The GT1SHWXPT02 decodes to about 2004-2008 by catalog convention — close enough to bracket the cartridge generation, not close enough to certify. The model code varies with trim, but the parts logic does not: trim codes shuffle doors and finishes; the EDR6D1 cartridge family is the fixed point.
Swap it in 5 minutes
- Twist the old cartridge a quarter turn counterclockwise and pull it straight down — keep a towel in reach for the dribble.
- Fill the new cartridge with cold tap water so the chamber is not fighting an air pocket.
- Offer the new cartridge to the bay, push up, and twist a quarter turn clockwise until the stop catches.
- Run two gallons through the dispenser to flush carbon fines, then hold the filter-reset control until the status light clears.
What this filter takes out of your water
| What it targets | Standard that covers it |
|---|---|
| Chlorine taste & odor | NSF/ANSI 42 — aesthetic effects |
| Particulates, Class I | NSF/ANSI 42 — fine sediment |
| Lead | NSF/ANSI 53 — health effects |
| Cysts (cryptosporidium, giardia) | NSF/ANSI 53 — microbial |
| PFOA & PFOS | NSF/ANSI 53 (P473) — varies by cartridge |
Coverage above lists what the standard addresses, not a performance claim for any specific cartridge — removal claims vary by certificate, so check the NSF listing for the exact part number you are buying.
GT1SHWXPT02 filter questions
Filter light reset on the Whirlpool GT1SHWXPT02 — how?
Press and hold the reset control until the light clears (a few seconds), with the new cartridge already seated — the GT1SHWXPT02 owner’s manual lists the button location for your control panel.
Whirlpool GT1SHWXPT02: bypass plug needed without a filter?
No — the EDR6D1 bay seals on the cartridge itself, so removing it just means unfiltered water until the next change, not a leak.
Are off-brand filters safe for a Whirlpool refrigerator?
Certified aftermarket cartridges are built to the same NSF test standards as the OEM part, and federal warranty law (Magnuson-Moss) protects your coverage when you use them.
Why is the OEM EDR6D1 cartridge so much more expensive?
Part of the OEM price is the badge and the distribution chain. Certified alternatives meet the same test standards at a lower unit price, especially in multi-packs.
How often should I replace the filter in my GT1SHWXPT02?
Every six months or at the rated gallon capacity, whichever comes first — the EDR6D1 class cartridges all share that service interval.
Do I need to turn off the water supply to change it?
No — the bay is designed for a live swap. Expect a small dribble, keep a towel in reach, and flush a couple of gallons through the new cartridge before the first glass.
Every filter that fits your fridge
This bay takes the OEM EDR6D1. ClearFit verified-fit alternatives for this exact slot are being staged — every compatible option for your fridge is one lookup away.
Check every filter that fits →This filter expires six months from today
Your HVAC filter is probably on a different cycle. Track them all in one place.
months until this filter should be replaced (200-gal rated life)
Free tool · tracks fridge + HVAC + whole-house · auto-refill optional
More models using this filter
Related guides
POPULAR GUIDE
How to change a Whirlpool refrigerator water filter
Every Filter 1–6 bay location — including the door-mounted bays on WRX models, with door-open angles and cap-release quirks. — read the guide →
POPULAR GUIDE
How to reset your Whirlpool filter light
Filter 1–6 indicator maps showing which key actually clears the light on your panel. — read the guide →
WATER PROBLEM GUIDE
Does your fridge filter remove fluoride?
What EDR1RXD1-class carbon blocks actually take out — and the systems that do remove fluoride. — read the guide →