Home › Refrigerator Water Filters › Whirlpool › GS2SHGXLQ00
Water Filter for the Whirlpool GS2SHGXLQ00 (EDR5RXD1)
✓ 100% compatible — no bypass plug needed
🔧 5-min push-in swap
🇺🇸 Ships from Indiana

Every cartridge that fits this model — pulled live from the catalogue:
✓
GS2SHGXLQ00 specifics — where the filter actually lives
The GS2SHGXLQ00 carries its water filter in the lower fresh-food zone in most side-by-side layouts, knee height or below — usually a kneeling-height or shoulder-height swap, not a teardown. It is a twist-lock bay: look for the index lugs, offer the cartridge, and rotate until they disappear into the housing.
Practical notes from the install forums: a stubborn first twist when the old o-ring has set, and a change-filter light that will not clear itself until you hold the reset. Read the prefix and the maintenance writes itself: it usually marks a side-by-side family layout, which means shared cartridge economics — one media family, dozens of cabinet variants, all drinking from the same parts line. Suffix 00 = production revision; filtration hardware was not part of the revision cycle.
GS vs GSS — what the prefix tells you
Know your GS from your GSS and the cartridge question halves: side-by-side family against side-by-side, respectively. Filter bays rarely care — the media family carries over more often than not. The GS2SHGXLQ00 code suggests roughly 2002-2006 production — approximately right, which is all a parts search needs.
Swap it in 5 minutes

- Twist the old cartridge a quarter turn counterclockwise and pull it straight down — keep a towel in reach for the dribble.
- Fill the new cartridge with cold tap water so the chamber is not fighting an air pocket.
- Offer the new cartridge to the bay, push up, and twist a quarter turn clockwise until the stop catches.
- Run two gallons through the dispenser to flush carbon fines, then hold the filter-reset control until the status light clears.
What this filter takes out of your water

| What it targets | Standard that covers it |
|---|---|
| Chlorine taste & odor | NSF/ANSI 42 — aesthetic effects |
| Particulates, Class I | NSF/ANSI 42 — fine sediment |
| Lead | NSF/ANSI 53 — health effects |
| Cysts (cryptosporidium, giardia) | NSF/ANSI 53 — microbial |
| PFOA & PFOS | NSF/ANSI 53 (P473) — varies by cartridge |
Coverage above lists what the standard addresses, not a performance claim for any specific cartridge — removal claims vary by certificate, so check the NSF listing for the exact part number you are buying.
GS2SHGXLQ00 filter questions
How to reset the water filter indicator: Whirlpool GS2SHGXLQ00?
Hold the filter-reset control a few seconds after seating the new cartridge; placements vary by control panel, and the GS2SHGXLQ00 manual’s filter-status page has the exact spot.
Is a bypass plug required for the GS2SHGXLQ00 when the cartridge is removed?
No — run it empty if you like; the EDR5RXD1 bay needs no bypass plug, it simply passes water through untreated.
Are off-brand filters safe for a Whirlpool refrigerator?
Certified aftermarket cartridges are built to the same NSF test standards as the OEM part, and federal warranty law (Magnuson-Moss) protects your coverage when you use them.
Why is the OEM EDR5RXD1 cartridge so much more expensive?
Part of the OEM price is the badge and the distribution chain. Certified alternatives meet the same test standards at a lower unit price, especially in multi-packs.
How often should I replace the filter in my GS2SHGXLQ00?
Every six months or at the rated gallon capacity, whichever comes first — the EDR5RXD1 class cartridges all share that service interval.
Do I need to turn off the water supply to change it?
No — the bay is designed for a live swap. Expect a small dribble, keep a towel in reach, and flush a couple of gallons through the new cartridge before the first glass.
Every filter that fits your fridge
This bay takes the OEM EDR5RXD1. ClearFit verified-fit alternatives for this exact slot are being staged — every compatible option for your fridge is one lookup away.
Check every filter that fits →This filter expires six months from today
Your HVAC filter is probably on a different cycle. Track them all in one place.
months until this filter should be replaced (200-gal rated life)
Free tool · tracks fridge + HVAC + whole-house · auto-refill optional
More models using this filter
Related guides
POPULAR GUIDE
How to change a Whirlpool refrigerator water filter
Every Filter 1–6 bay location — including the door-mounted bays on WRX models, with door-open angles and cap-release quirks. — read the guide →
POPULAR GUIDE
How to reset your Whirlpool filter light
Filter 1–6 indicator maps showing which key actually clears the light on your panel. — read the guide →
WATER PROBLEM GUIDE
Does your fridge filter remove fluoride?
What EDR1RXD1-class carbon blocks actually take out — and the systems that do remove fluoride. — read the guide →