HomeRefrigerator Water FiltersWhirlpoolGD2SHAXLT00

GD2SHAXLT00
Exact-Fit Model Guide

Water Filter for the Whirlpool GD2SHAXLT00 (EDR5RXD1)

Your Whirlpool refrigerator takes the EDR5RXD1 slot. Below is every filter that fits — OEM and certified alternatives — with real prices.

✓ 100% compatible — no bypass plug needed

🔧 5-min push-in swap

🇺🇸 Ships from Indiana

GD2SHAXLT00 · Quick Facts
TYPE
refrigerator
YEARS MADE
2002-2006
FILTER LOCATION
in the fresh-food compartment, placement dependent on the dispenser package
FILTER SLOT
EveryDrop Filter 5 bay
REPLACE EVERY
Every 6 months
ALSO BRANDED AS
GD2SHAXLT00 · Quick Facts
Filter locationin the fresh-food compartment, placement dependent on the dispenser package
Filter slotEveryDrop Filter 5 bay
Replace everyEvery 6 months
Years made2002-2006
Typical installTwist or push — 5 minutes, no tools

Every cartridge that fits this model — pulled live from the catalogue:

Verified fit for GD2SHAXLT00. Cross-checked against Whirlpool service documentation — this model family uses the EDR5RXD1 bay with no chip or bypass restrictions.

GD2SHAXLT00 specifics — where the filter actually lives

The filter bay on the GD2SHAXLT00 in the fresh-food compartment, placement dependent on the dispenser package, a spot that survives trim changes across the refrigerator run. Mechanically the GD2SHAXLT00 uses a twist-in cartridge: the ears on the cartridge neck are the guide — line them up, lift into the seat, and quarter-turn home.

Order-day practicalities: a first removal that fights a set o-ring, and a status light that needs a manual hold-to-reset before it acknowledges the new cartridge. Whatever the badge on the door says, the parts reality is the EDR5RXD1 line — which is why fit listings key on chassis rather than door style. The -00 tail tracks the revision ladder — each rung shares the identical EDR5RXD1 bay.

Reading the GD2SHAXLT00 model code — what the digits tell you

Working from the model code, the GD2SHAXLT00 lands somewhere around 2002-2006; treat the window as approximate. The trim walk never reaches the plumbing: every variant of this chassis locks onto the EDR5RXD1 line — that is the whole parts story.

Swap it in 5 minutes

  • Twist the old cartridge a quarter turn counterclockwise and pull it straight down — keep a towel in reach for the dribble.
  • Fill the new cartridge with cold tap water so the chamber is not fighting an air pocket.
  • Offer the new cartridge to the bay, push up, and twist a quarter turn clockwise until the stop catches.
  • Run two gallons through the dispenser to flush carbon fines, then hold the filter-reset control until the status light clears.

What this filter takes out of your water

What it targetsStandard that covers it
Chlorine taste & odorNSF/ANSI 42 — aesthetic effects
Particulates, Class INSF/ANSI 42 — fine sediment
LeadNSF/ANSI 53 — health effects
Cysts (cryptosporidium, giardia)NSF/ANSI 53 — microbial
PFOA & PFOSNSF/ANSI 53 (P473) — varies by cartridge

Coverage above lists what the standard addresses, not a performance claim for any specific cartridge — removal claims vary by certificate, so check the NSF listing for the exact part number you are buying.

GD2SHAXLT00 filter questions

Whirlpool GD2SHAXLT00: how do I clear the change-filter light?

Hold the filter-reset control a few seconds after seating the new cartridge; placements vary by control panel, and the GD2SHAXLT00 manual’s filter-status page has the exact spot.

Whirlpool GD2SHAXLT00: bypass plug needed without a filter?

No cap needed — the EDR5RXD1 bay passes water unfiltered while empty; it does not leak, it just skips filtration.

Are off-brand filters safe for a Whirlpool refrigerator?

Certified aftermarket cartridges are built to the same NSF test standards as the OEM part, and federal warranty law (Magnuson-Moss) protects your coverage when you use them.

Why is the OEM EDR5RXD1 cartridge so much more expensive?

Part of the OEM price is the badge and the distribution chain. Certified alternatives meet the same test standards at a lower unit price, especially in multi-packs.

How often should I replace the filter in my GD2SHAXLT00?

Every six months or at the rated gallon capacity, whichever comes first — the EDR5RXD1 class cartridges all share that service interval.

Do I need to turn off the water supply to change it?

No — the bay is designed for a live swap. Expect a small dribble, keep a towel in reach, and flush a couple of gallons through the new cartridge before the first glass.

Every filter that fits your fridge

OEM EDR5RXD1 cartridge

This bay takes the OEM EDR5RXD1. ClearFit verified-fit alternatives for this exact slot are being staged — every compatible option for your fridge is one lookup away.

Check every filter that fits →

This filter expires six months from today

Your HVAC filter is probably on a different cycle. Track them all in one place.

6

months until this filter should be replaced (200-gal rated life)

Free tool · tracks fridge + HVAC + whole-house · auto-refill optional

More models using this filter

refrigerator
refrigerator
refrigerator
refrigerator

Related guides

GUIDE · 4,400 SEARCHES/MO

How to change a Whirlpool refrigerator water filter

Every Filter 1–6 bay location — including the door-mounted bays on WRX models, with door-open angles and cap-release quirks. — read the guide →

GUIDE · 2,300 SEARCHES/MO

How to reset your Whirlpool filter light

Filter 1–6 indicator maps showing which key actually clears the light on your panel. — read the guide →

WATER PROBLEM · 27,100 SEARCHES/MO

Does your fridge filter remove fluoride?

What EDR1RXD1-class carbon blocks actually take out — and the systems that do remove fluoride. — read the guide →