Water Filter for the Samsung RS267BBRS (DA29-00003G)

RS267BBRS specifics — where the filter actually lives

The filter bay on the RS267BBRS at the base of the fresh-food compartment in most side-by-side builds — grille or lower rear, a spot that survives trim changes across the RS run. This is a push-style bay, the simplest geometry there is: the header accepts the cartridge one way; when it slides without force, it is aligned.

Practical notes from the install forums: a stubborn first twist when the old o-ring has set, and a change-filter light that will not clear itself until you hold the reset. Decode the plate and the parts question answers itself: Samsung built these as side-by-side machines, and the filter bay inherits the geometry that implies, including where the dispenser feed runs. That RS suffix is trim-level shorthand. Samsung kept the DA2900003G bay common to every finish in the line.

RS vs RF — what the prefix tells you

The RS prefix sits next to RF in the catalog and the split is cabinet mission: RS covers side-by-side, while RF covers French-door multi-door. The cartridge line is usually shared across both — order by chassis, not by door count. Cabinet decode: 26 cu ft — the number that tells you whether this cartridge feeds a family-size dispenser or a compact one.

Swap it in 5 minutes

• Pull the old cartridge straight out of the header — expect a small spill, not a flood.
• Align the new cartridge with the keyed slot; it only goes in one orientation.
• Push the cartridge home until the retention latch clicks.
• Run two gallons through the dispenser to flush carbon fines, then hold the filter-reset control until the status light clears.

What this filter takes out of your water

Coverage above lists what the standard addresses, not a performance claim for any specific cartridge — removal claims vary by certificate, so check the NSF listing for the exact part number you are buying.

RS267BBRS filter questions