HomeRefrigerator Water FiltersGEPSW26LSRDSS

PSW26LSRDSS
Exact-Fit Model Guide

Water Filter for the GE PSW26LSRDSS (MWF)

Your GE refrigerator takes the MWF slot. Below is every filter that fits — OEM and certified alternatives — with real prices.

✓ 100% compatible — no bypass plug needed

🔧 5-min push-in swap

🇺🇸 Ships from Indiana

PSW26LSRDSS replacement water filter cartridge
Replacement cartridge for this model
PSW26LSRDSS · Quick Facts
TYPE
refrigerator
YEARS MADE
FILTER LOCATION
in the fresh-food compartment, placement dependent on the dispenser package
FILTER SLOT
MWF bay
REPLACE EVERY
Every 6 months
ALSO BRANDED AS
PSW26LSRDSS · Quick Facts
Filter locationin the fresh-food compartment, placement dependent on the dispenser package
Filter slotMWF bay
Replace everyEvery 6 months
Typical installTwist or push — 5 minutes, no tools

Every cartridge that fits this model — pulled live from the catalogue:

Verified fit for PSW26LSRDSS. Cross-checked against GE service documentation — this model family uses the MWF bay with no chip or bypass restrictions.

PSW26LSRDSS specifics — where the filter actually lives

The PSW26LSRDSS carries its water filter in the fresh-food compartment, placement dependent on the dispenser package — usually a kneeling-height or shoulder-height swap, not a teardown. Mechanically it is a quarter-turn twist-in seat: no tools, no housing removal, and the cartridge indexes in only one orientation despite looking symmetric.

Two quirks worth knowing before you order: the change light ignores the new cartridge until you reset it, and the first removal always takes more muscle than the manual implies. What pins the parts choice down is the media line: this chassis drinks from the MWF family, one of the most cross-referenced cartridges in the GE catalog. The SS tail marks finish variants of one chassis; the filter bay is shared across the entire finish range.

Reading the PSW26LSRDSS model code — what the digits tell you

Read the code as 26 cu ft of capacity, which tells you the cartridge’s real workload between changes. What stays constant across the trim range: the MWF cartridge is the one constant across the model run.

Swap it in 5 minutes

Installing the replacement water filter in the PSW26LSRDSS
  • Twist the old cartridge a quarter turn counterclockwise and pull it straight down — keep a towel in reach for the dribble.
  • Fill the new cartridge with cold tap water so the chamber is not fighting an air pocket.
  • Offer the new cartridge to the bay, push up, and twist a quarter turn clockwise until the stop catches.
  • Run two gallons through the dispenser to flush carbon fines, then hold the filter-reset control until the status light clears.

What this filter takes out of your water

Old cartridge vs new — the difference a timely swap makes
What it targetsStandard that covers it
Chlorine taste & odorNSF/ANSI 42 — aesthetic effects
Particulates, Class INSF/ANSI 42 — fine sediment
LeadNSF/ANSI 53 — health effects
Cysts (cryptosporidium, giardia)NSF/ANSI 53 — microbial
PFOA & PFOSNSF/ANSI 53 (P473) — varies by cartridge

Coverage above lists what the standard addresses, not a performance claim for any specific cartridge — removal claims vary by certificate, so check the NSF listing for the exact part number you are buying.

PSW26LSRDSS filter questions

How do I reset the filter light on the GE PSW26LSRDSS?

Press and hold the reset control until the light clears (a few seconds), with the new cartridge already seated — the PSW26LSRDSS owner’s manual lists the button location for your control panel.

Running the PSW26LSRDSS with an empty filter bay — does it need a cap?

Nothing to buy — the MWF housing closes without a cartridge; water runs unfiltered until the next one goes in.

Are off-brand filters safe for a GE refrigerator?

Certified aftermarket cartridges are built to the same NSF test standards as the OEM part, and federal warranty law (Magnuson-Moss) protects your coverage when you use them.

Why is the OEM MWF cartridge so much more expensive?

Part of the OEM price is the badge and the distribution chain. Certified alternatives meet the same test standards at a lower unit price, especially in multi-packs.

How often should I replace the filter in my PSW26LSRDSS?

Every six months or at the rated gallon capacity, whichever comes first — the MWF class cartridges all share that service interval.

Do I need to turn off the water supply to change it?

No — the bay is designed for a live swap. Expect a small dribble, keep a towel in reach, and flush a couple of gallons through the new cartridge before the first glass.

Every filter that fits your fridge

OEM MWF cartridge

This bay takes the OEM MWF. ClearFit verified-fit alternatives for this exact slot are being staged — every compatible option for your fridge is one lookup away.

Check every filter that fits →

This filter expires six months from today

Your HVAC filter is probably on a different cycle. Track them all in one place.

6

months until this filter should be replaced (200-gal rated life)

Free tool · tracks fridge + HVAC + whole-house · auto-refill optional

More models using this filter

refrigerator
refrigerator
refrigerator
refrigerator

Related guides

POPULAR GUIDE

How to change a Whirlpool refrigerator water filter

Every Filter 1–6 bay location — including the door-mounted bays on WRX models, with door-open angles and cap-release quirks. — read the guide →

POPULAR GUIDE

How to reset your Whirlpool filter light

Filter 1–6 indicator maps showing which key actually clears the light on your panel. — read the guide →

WATER PROBLEM GUIDE

Does your fridge filter remove fluoride?

What EDR1RXD1-class carbon blocks actually take out — and the systems that do remove fluoride. — read the guide →