Home › Refrigerator Water Filters › GE › PSS28KSHSS
Water Filter for the Profile PSS28KSHSS (XWF)
✓ 100% compatible — no bypass plug needed
🔧 5-min push-in swap
🇺🇸 Ships from Indiana

Every cartridge that fits this model — pulled live from the catalogue:
✓
PSS28KSHSS specifics — where the filter actually lives
The PSS28KSHSS carries its water filter bottom of the fresh-food column or at the grille line in most side-by-side builds, a spot that survives trim changes across the PSS run. This is a twist-style bay, the friendlier design: no tools, no housing removal, and the cartridge indexes in only one orientation despite looking symmetric.
Practical notes from the install forums: a stubborn first twist when the old o-ring has set, and a change-filter light that will not clear itself until you hold the reset. One prefix, one chassis family: PSS is GE’s Profile side-by-side designation proper, and the service literature files every one of these under the same cartridge line. That SS suffix is trim-level shorthand. GE kept the XWF bay common to every finish in the line.
PSS vs GSS — what the prefix tells you
Two prefixes, two missions: PSS means Profile side-by-side, GSS means side-by-side. For filter shopping the distinction matters less than you would think — same line, different cabinet. The digits in the model number read as cabinet capacity (28 cu ft), a decent proxy for how hard the filter works in daily service.
Swap it in 5 minutes

- Twist the old cartridge a quarter turn counterclockwise and pull it straight down — keep a towel in reach for the dribble.
- Fill the new cartridge with cold tap water so the chamber is not fighting an air pocket.
- Offer the new cartridge to the bay, push up, and twist a quarter turn clockwise until the stop catches.
- Run two gallons through the dispenser to flush carbon fines, then hold the filter-reset control until the status light clears.
What this filter takes out of your water

| What it targets | Standard that covers it |
|---|---|
| Chlorine taste & odor | NSF/ANSI 42 — aesthetic effects |
| Particulates, Class I | NSF/ANSI 42 — fine sediment |
| Lead | NSF/ANSI 53 — health effects |
| Cysts (cryptosporidium, giardia) | NSF/ANSI 53 — microbial |
| PFOA & PFOS | NSF/ANSI 53 (P473) — varies by cartridge |
Coverage above lists what the standard addresses, not a performance claim for any specific cartridge — removal claims vary by certificate, so check the NSF listing for the exact part number you are buying.
PSS28KSHSS filter questions
GE PSS28KSHSS: how do I clear the change-filter light?
Seat the new cartridge first, then hold the filter-reset control for a few seconds until the status light clears — the exact button placement varies by control panel, so check the PSS28KSHSS owner’s manual page for filter status.
Does the GE PSS28KSHSS need a bypass plug when the filter is out?
No — the XWF bay seals on the cartridge itself, so removing it just means unfiltered water until the next change, not a leak.
Are off-brand filters safe for a GE refrigerator?
Certified aftermarket cartridges are built to the same NSF test standards as the OEM part, and federal warranty law (Magnuson-Moss) protects your coverage when you use them.
Why is the OEM XWF cartridge so much more expensive?
Part of the OEM price is the badge and the distribution chain. Certified alternatives meet the same test standards at a lower unit price, especially in multi-packs.
How often should I replace the filter in my PSS28KSHSS?
Every six months or at the rated gallon capacity, whichever comes first — the XWF class cartridges all share that service interval.
Do I need to turn off the water supply to change it?
No — the bay is designed for a live swap. Expect a small dribble, keep a towel in reach, and flush a couple of gallons through the new cartridge before the first glass.
Every filter that fits your fridge
| Cartridge | OEM XWF | RECOMMENDEDXWFE Replacement Water Filter · 1-Pack – ClearFit | XWFE Replacement Water Filter · 3-Pack – ClearFit | XWFE Replacement Water Filter · 6-Pack – ClearFit |
|---|---|---|---|---|
| Price | OEM list | $15.99 | $39.96 | $71.94 |
| Verified fit | ✓ the bay cartridge | View & buy → | View & buy → | View & buy → |
This filter expires six months from today
Your HVAC filter is probably on a different cycle. Track them all in one place.
months until this filter should be replaced (200-gal rated life)
Free tool · tracks fridge + HVAC + whole-house · auto-refill optional
More models using this filter
Related guides
POPULAR GUIDE
How to change a Whirlpool refrigerator water filter
Every Filter 1–6 bay location — including the door-mounted bays on WRX models, with door-open angles and cap-release quirks. — read the guide →
POPULAR GUIDE
How to reset your Whirlpool filter light
Filter 1–6 indicator maps showing which key actually clears the light on your panel. — read the guide →
WATER PROBLEM GUIDE
Does your fridge filter remove fluoride?
What EDR1RXD1-class carbon blocks actually take out — and the systems that do remove fluoride. — read the guide →