Home › Refrigerator Water Filters › GE › PSF26PGSABB
Water Filter for the Profile PSF26PGSABB (MWF)
✓ 100% compatible — no bypass plug needed
🔧 5-min push-in swap
🇺🇸 Ships from Indiana
Every cartridge that fits this model — pulled live from the catalogue:
✓
PSF26PGSABB specifics — where the filter actually lives
Finding the bay is the easy part — this chassis puts it upper rear of the fresh-food section in most French-door builds with interior dispensers, a spot that survives trim changes across the PSF run. It is a twist-lock bay: the bay wants the cartridge offered flat, rotated a quarter turn, and nothing more — hand pressure only.
Practical notes from the install forums: keep a folded towel under the bay before you open it; the line holds a cup of water even with the valve shut. The badge reads PSF26PGSABB, but the chassis reads PSF: it usually marks a Profile French-door layout, which means shared cartridge economics — one media family, dozens of cabinet variants, all drinking from the same parts line. Finish letter sets like BB never alter the bay; the MWF line fits the whole set.
PSF vs the rest of the catalog — what the prefix tells you
Same parts shelf, two cabinet missions — PSF marks Profile French-door builds and the rest of the catalog marks the neighboring layout builds. Cross-checking the prefix before ordering is faster than returning the wrong cartridge. 26 cubic feet of cabinet — the dispenser sees heavy traffic at that size, and heavy traffic ages cartridges faster.
Swap it in 5 minutes
- Twist the old cartridge a quarter turn counterclockwise and pull it straight down — keep a towel in reach for the dribble.
- Fill the new cartridge with cold tap water so the chamber is not fighting an air pocket.
- Offer the new cartridge to the bay, push up, and twist a quarter turn clockwise until the stop catches.
- Run two gallons through the dispenser to flush carbon fines, then hold the filter-reset control until the status light clears.
What this filter takes out of your water
| What it targets | Standard that covers it |
|---|---|
| Chlorine taste & odor | NSF/ANSI 42 — aesthetic effects |
| Particulates, Class I | NSF/ANSI 42 — fine sediment |
| Lead | NSF/ANSI 53 — health effects |
| Cysts (cryptosporidium, giardia) | NSF/ANSI 53 — microbial |
| PFOA & PFOS | NSF/ANSI 53 (P473) — varies by cartridge |
Coverage above lists what the standard addresses, not a performance claim for any specific cartridge — removal claims vary by certificate, so check the NSF listing for the exact part number you are buying.
PSF26PGSABB filter questions
How do I reset the filter light on the GE PSF26PGSABB?
Hold the filter-reset control a few seconds after the swap; the status light clears only with a seated cartridge, and the PSF26PGSABB manual maps the control by panel type.
Can I run the GE PSF26PGSABB with no cartridge installed?
No — the MWF bay seals on the cartridge itself, so removing it just means unfiltered water until the next change, not a leak.
Are off-brand filters safe for a GE refrigerator?
Certified aftermarket cartridges are built to the same NSF test standards as the OEM part, and federal warranty law (Magnuson-Moss) protects your coverage when you use them.
Why is the OEM MWF cartridge so much more expensive?
Part of the OEM price is the badge and the distribution chain. Certified alternatives meet the same test standards at a lower unit price, especially in multi-packs.
How often should I replace the filter in my PSF26PGSABB?
Every six months or at the rated gallon capacity, whichever comes first — the MWF class cartridges all share that service interval.
Do I need to turn off the water supply to change it?
No — the bay is designed for a live swap. Expect a small dribble, keep a towel in reach, and flush a couple of gallons through the new cartridge before the first glass.
Every filter that fits your fridge
| Cartridge | OEM MWF | RECOMMENDEDMWF Replacement Water Filter · 1-Pack – ClearFit | MWF Replacement Water Filter · 3-Pack – ClearFit | MWF Replacement Water Filter · 6-Pack – ClearFit |
|---|---|---|---|---|
| Price | OEM list | $14.99 | $37.47 | $67.44 |
| Verified fit | ✓ the bay cartridge | View & buy → | View & buy → | View & buy → |
This filter expires six months from today
Your HVAC filter is probably on a different cycle. Track them all in one place.
months until this filter should be replaced (200-gal rated life)
Free tool · tracks fridge + HVAC + whole-house · auto-refill optional
More models using this filter
Related guides
POPULAR GUIDE
How to change a Whirlpool refrigerator water filter
Every Filter 1–6 bay location — including the door-mounted bays on WRX models, with door-open angles and cap-release quirks. — read the guide →
POPULAR GUIDE
How to reset your Whirlpool filter light
Filter 1–6 indicator maps showing which key actually clears the light on your panel. — read the guide →
WATER PROBLEM GUIDE
Does your fridge filter remove fluoride?
What EDR1RXD1-class carbon blocks actually take out — and the systems that do remove fluoride. — read the guide →