Water Filter for the GE GSH25JFPDWW (MWF)

GSH25JFPDWW specifics — where the filter actually lives

On the GSH25JFPDWW, the cartridge at the base of the fresh-food compartment in most side-by-side builds — grille or lower rear, so expect to clear one shelf edge before you have working room. The seat is a twist-in design — align the ears, seat it, and rotate until the stop catches — a five-minute job start to finish.

Practical notes from the install forums: a first removal that fights a set o-ring, and a status light that needs a manual hold-to-reset before it acknowledges the new cartridge. The badge reads GSH25JFPDWW, but the chassis reads GSH: GSH on this badge family usually means side-by-side variant stock, which is why fit charts list cartridges by chassis code first. Trim code WW: cosmetic variants of one chassis, one cartridge family.

GSH vs GSS — what the prefix tells you

The GSH/GSS pair divides this family by layout — GSH marks side-by-side variant builds and GSS marks side-by-side builds. Cross-checking the prefix before ordering is faster than returning the wrong cartridge. read the code as 25 cubic feet of capacity, which tells you the cartridge’s real workload between changes.

Swap it in 5 minutes

• Twist the old cartridge a quarter turn counterclockwise and pull it straight down — keep a towel in reach for the dribble.
• Fill the new cartridge with cold tap water so the chamber is not fighting an air pocket.
• Offer the new cartridge to the bay, push up, and twist a quarter turn clockwise until the stop catches.
• Run two gallons through the dispenser to flush carbon fines, then hold the filter-reset control until the status light clears.

What this filter takes out of your water

Coverage above lists what the standard addresses, not a performance claim for any specific cartridge — removal claims vary by certificate, so check the NSF listing for the exact part number you are buying.

GSH25JFPDWW filter questions