Home › Refrigerator Water Filters › Frigidaire › GLRS264ZAQ0
Water Filter for the Frigidaire GLRS264ZAQ0 (WF2CB)
✓ 100% compatible — no bypass plug needed
🔧 5-min push-in swap
🇺🇸 Ships from Indiana
Every cartridge that fits this model — pulled live from the catalogue:
✓
GLRS264ZAQ0 specifics — where the filter actually lives
Finding the bay is the easy part — this chassis puts it at the base of the fresh-food compartment in most side-by-side builds — grille or lower rear, a spot that survives trim changes across the GLRS run. Mechanically the GLRS264ZAQ0 uses a twist-in cartridge: align the ears, seat it, and rotate until the stop catches — a five-minute job start to finish.
Two quirks worth knowing before you order: a first removal that fights a set o-ring, and a status light that needs a manual hold-to-reset before it acknowledges the new cartridge. GLRS reads as a chassis statement rather than a trim code: in this catalog GLRS is the side-by-side marker; internal layouts vary, the bay layout does not. Trailing letters like Q0 denote trim and finish: stainless, panel-ready, handle variants. The water path is identical across them.
GLRS vs the rest of the catalog — what the prefix tells you
The GLRS/the rest of the catalog pair divides this family by layout — GLRS answers to side-by-side; the rest of the catalog answers to the neighboring layout; the water-filter answer is shared. read the code as 26 cu ft of capacity, which tells you the cartridge’s real workload between changes.
Swap it in 5 minutes
- Twist the old cartridge a quarter turn counterclockwise and pull it straight down — keep a towel in reach for the dribble.
- Fill the new cartridge with cold tap water so the chamber is not fighting an air pocket.
- Offer the new cartridge to the bay, push up, and twist a quarter turn clockwise until the stop catches.
- Run two gallons through the dispenser to flush carbon fines, then hold the filter-reset control until the status light clears.
What this filter takes out of your water
| What it targets | Standard that covers it |
|---|---|
| Chlorine taste & odor | NSF/ANSI 42 — aesthetic effects |
| Particulates, Class I | NSF/ANSI 42 — fine sediment |
| Lead | NSF/ANSI 53 — health effects |
| Cysts (cryptosporidium, giardia) | NSF/ANSI 53 — microbial |
| PFOA & PFOS | NSF/ANSI 53 (P473) — varies by cartridge |
Coverage above lists what the standard addresses, not a performance claim for any specific cartridge — removal claims vary by certificate, so check the NSF listing for the exact part number you are buying.
GLRS264ZAQ0 filter questions
How do I reset the filter light on the Frigidaire GLRS264ZAQ0?
Seat the new cartridge first, then hold the filter-reset control for a few seconds until the status light clears — the exact button placement varies by control panel, so check the GLRS264ZAQ0 owner’s manual page for filter status.
Running the GLRS264ZAQ0 with an empty filter bay — does it need a cap?
Nothing to buy — the WF2CB housing closes without a cartridge; water runs unfiltered until the next one goes in.
Are off-brand filters safe for a Frigidaire refrigerator?
Certified aftermarket cartridges are built to the same NSF test standards as the OEM part, and federal warranty law (Magnuson-Moss) protects your coverage when you use them.
Why is the OEM WF2CB cartridge so much more expensive?
Part of the OEM price is the badge and the distribution chain. Certified alternatives meet the same test standards at a lower unit price, especially in multi-packs.
How often should I replace the filter in my GLRS264ZAQ0?
Every six months or at the rated gallon capacity, whichever comes first — the WF2CB class cartridges all share that service interval.
Do I need to turn off the water supply to change it?
No — the bay is designed for a live swap. Expect a small dribble, keep a towel in reach, and flush a couple of gallons through the new cartridge before the first glass.
Every filter that fits your fridge
This bay takes the OEM WF2CB. ClearFit verified-fit alternatives for this exact slot are being staged — every compatible option for your fridge is one lookup away.
Check every filter that fits →This filter expires six months from today
Your HVAC filter is probably on a different cycle. Track them all in one place.
months until this filter should be replaced (200-gal rated life)
Free tool · tracks fridge + HVAC + whole-house · auto-refill optional
More models using this filter
Related guides
POPULAR GUIDE
How to change a Whirlpool refrigerator water filter
Every Filter 1–6 bay location — including the door-mounted bays on WRX models, with door-open angles and cap-release quirks. — read the guide →
POPULAR GUIDE
How to reset your Whirlpool filter light
Filter 1–6 indicator maps showing which key actually clears the light on your panel. — read the guide →
WATER PROBLEM GUIDE
Does your fridge filter remove fluoride?
What EDR1RXD1-class carbon blocks actually take out — and the systems that do remove fluoride. — read the guide →