Water Filter for the Frigidaire GLHS67EHQ1 (WF2CB)

GLHS67EHQ1 specifics — where the filter actually lives

The GLHS67EHQ1 carries its water filter in the lower fresh-food zone in most side-by-side layouts, knee height or below, a deliberate placement that keeps the swap away from the door seals and drawer rails. Mechanically the GLHS67EHQ1 uses a twist-in cartridge: half a turn of wrist work in each direction is the whole procedure; everything else is towel management.

Practical notes from the install forums: a first removal that fights a set o-ring, and a status light that needs a manual hold-to-reset before it acknowledges the new cartridge. One prefix, one chassis family: generally a side-by-side machine, and the filter bay inherits the geometry that implies — treat as typical, not absolute. That Q1 suffix is trim-level shorthand. Frigidaire kept the WF2CB bay common to every finish in the line.

GLHS vs FFSS — what the prefix tells you

Both prefixes sort into side-by-side stock; generations differ, the cartridge line does not. One more anchor for the parts search: the GLHS67EHQ1 shares its water path with the whole WF2CB generation — the cartridge is the common denominator, not the door count.

Swap it in 5 minutes

• Twist the old cartridge a quarter turn counterclockwise and pull it straight down — keep a towel in reach for the dribble.
• Fill the new cartridge with cold tap water so the chamber is not fighting an air pocket.
• Offer the new cartridge to the bay, push up, and twist a quarter turn clockwise until the stop catches.
• Run two gallons through the dispenser to flush carbon fines, then hold the filter-reset control until the status light clears.

What this filter takes out of your water

Coverage above lists what the standard addresses, not a performance claim for any specific cartridge — removal claims vary by certificate, so check the NSF listing for the exact part number you are buying.

GLHS67EHQ1 filter questions