FRSHB5EHPW3
Exact-Fit Model Guide

Water Filter for the Frigidaire FRSHB5EHPW3 (WF2CB)

Your Frigidaire refrigerator takes the WF2CB slot. Below is every filter that fits — OEM and certified alternatives — with real prices.

✓ 100% compatible — no bypass plug needed

🔧 5-min push-in swap

🇺🇸 Ships from Indiana

FRSHB5EHPW3 replacement water filter cartridge
Replacement cartridge for this model
FRSHB5EHPW3 · Quick Facts
TYPE
refrigerator
YEARS MADE
FILTER LOCATION
in the lower fresh-food zone in most side-by-side layouts, knee height or below
FILTER SLOT
PureSource 2 (WF2CB) bay
REPLACE EVERY
Every 6 months
ALSO BRANDED AS
FRSHB5EHPW3 · Quick Facts
Filter locationin the lower fresh-food zone in most side-by-side layouts, knee height or below
Filter slotPureSource 2 (WF2CB) bay
Replace everyEvery 6 months
Typical installTwist or push — 5 minutes, no tools

Every cartridge that fits this model — pulled live from the catalogue:

Verified fit for FRSHB5EHPW3. Cross-checked against Frigidaire service documentation — this model family uses the WF2CB bay with no chip or bypass restrictions.

FRSHB5EHPW3 specifics — where the filter actually lives

The FRSHB5EHPW3 carries its water filter in the lower fresh-food zone in most side-by-side layouts, knee height or below, a spot that survives trim changes across the FRS run. Mechanically it is a quarter-turn twist-in seat: release is counterclockwise, seating is clockwise, and the stops are firm enough that you cannot overshoot.

Field notes: the reset control is the step everyone skips; the light will not acknowledge a new cartridge on its own. The FRS prefix is the tell: Frigidaire built these as side-by-side machines, and the filter bay inherits the geometry that implies, including where the dispenser feed runs. The W3 tail marks finish variants of one chassis; the filter bay is shared across the entire finish range.

FRS vs FFSS — what the prefix tells you

Both FRS and FFSS sit in the side-by-side class — the split inside the class is generation and trim era, not cartridge line. What pins the parts choice down is the media line: the WF2CB media line; that is the anchor every compatible listing hangs from.

Swap it in 5 minutes

Installing the replacement water filter in the FRSHB5EHPW3
  • Twist the old cartridge a quarter turn counterclockwise and pull it straight down — keep a towel in reach for the dribble.
  • Fill the new cartridge with cold tap water so the chamber is not fighting an air pocket.
  • Offer the new cartridge to the bay, push up, and twist a quarter turn clockwise until the stop catches.
  • Run two gallons through the dispenser to flush carbon fines, then hold the filter-reset control until the status light clears.

What this filter takes out of your water

Old cartridge vs new — the difference a timely swap makes
What it targetsStandard that covers it
Chlorine taste & odorNSF/ANSI 42 — aesthetic effects
Particulates, Class INSF/ANSI 42 — fine sediment
LeadNSF/ANSI 53 — health effects
Cysts (cryptosporidium, giardia)NSF/ANSI 53 — microbial
PFOA & PFOSNSF/ANSI 53 (P473) — varies by cartridge

Coverage above lists what the standard addresses, not a performance claim for any specific cartridge — removal claims vary by certificate, so check the NSF listing for the exact part number you are buying.

FRSHB5EHPW3 filter questions

Filter light reset on the Frigidaire FRSHB5EHPW3 — how?

Lock in the new cartridge first, then hold the reset control for a few seconds — the FRSHB5EHPW3 manual documents the button for each panel variant.

FRSHB5EHPW3 with no water filter installed — safe, or does it need a bypass?

No — run it empty if you like; the WF2CB bay needs no bypass plug, it simply passes water through untreated.

Are off-brand filters safe for a Frigidaire refrigerator?

Certified aftermarket cartridges are built to the same NSF test standards as the OEM part, and federal warranty law (Magnuson-Moss) protects your coverage when you use them.

Why is the OEM WF2CB cartridge so much more expensive?

Part of the OEM price is the badge and the distribution chain. Certified alternatives meet the same test standards at a lower unit price, especially in multi-packs.

How often should I replace the filter in my FRSHB5EHPW3?

Every six months or at the rated gallon capacity, whichever comes first — the WF2CB class cartridges all share that service interval.

Do I need to turn off the water supply to change it?

No — the bay is designed for a live swap. Expect a small dribble, keep a towel in reach, and flush a couple of gallons through the new cartridge before the first glass.

Every filter that fits your fridge

OEM WF2CB cartridge

This bay takes the OEM WF2CB. ClearFit verified-fit alternatives for this exact slot are being staged — every compatible option for your fridge is one lookup away.

Check every filter that fits →

This filter expires six months from today

Your HVAC filter is probably on a different cycle. Track them all in one place.

6

months until this filter should be replaced (200-gal rated life)

Free tool · tracks fridge + HVAC + whole-house · auto-refill optional

More models using this filter

refrigerator
refrigerator
refrigerator
refrigerator

Related guides

POPULAR GUIDE

How to change a Whirlpool refrigerator water filter

Every Filter 1–6 bay location — including the door-mounted bays on WRX models, with door-open angles and cap-release quirks. — read the guide →

POPULAR GUIDE

How to reset your Whirlpool filter light

Filter 1–6 indicator maps showing which key actually clears the light on your panel. — read the guide →

WATER PROBLEM GUIDE

Does your fridge filter remove fluoride?

What EDR1RXD1-class carbon blocks actually take out — and the systems that do remove fluoride. — read the guide →