Water Filter for the Electrolux EI26SS35JB1 (WF2CB)

EI26SS35JB1 specifics — where the filter actually lives

The filter bay on the EI26SS35JB1 upper rear of the fresh-food section in most French-door builds with interior dispensers, a deliberate placement that keeps the swap away from the door seals and drawer rails. The seat is a twist-in design — no tools, no housing removal, and the cartridge indexes in only one orientation despite looking symmetric.

The small print owners learn the hard way: a stubborn first twist when the old o-ring has set, and a change-filter light that will not clear itself until you hold the reset. Decode the plate and the parts question answers itself: EI on this badge family usually means French-door stock, which is why fit charts list cartridges by chassis code first. Finish letter sets like B1 never alter the bay; the WF2CB line fits the whole set.

EI vs EW — what the prefix tells you

Same parts shelf, two cabinet missions — The French-door/Wave-Touch Electrolux French-door split tracks the EI/EW prefixes — cartridge fit follows the water path, not the label on the door. Size class 26 cubic feet — worth knowing because a full household works a cartridge harder than the rated six months assumes.

Swap it in 5 minutes

• Twist the old cartridge a quarter turn counterclockwise and pull it straight down — keep a towel in reach for the dribble.
• Fill the new cartridge with cold tap water so the chamber is not fighting an air pocket.
• Offer the new cartridge to the bay, push up, and twist a quarter turn clockwise until the stop catches.
• Run two gallons through the dispenser to flush carbon fines, then hold the filter-reset control until the status light clears.

What this filter takes out of your water

Coverage above lists what the standard addresses, not a performance claim for any specific cartridge — removal claims vary by certificate, so check the NSF listing for the exact part number you are buying.

EI26SS35JB1 filter questions