EI24RD65KS1
Exact-Fit Model Guide

Water Filter for the Electrolux EI24RD65KS1 (WF2CB)

Your Frigidaire refrigerator takes the WF2CB slot. Below is every filter that fits — OEM and certified alternatives — with real prices.

✓ 100% compatible — no bypass plug needed

🔧 5-min push-in swap

🇺🇸 Ships from Indiana

EI24RD65KS1 replacement water filter cartridge
Replacement cartridge for this model
EI24RD65KS1 · Quick Facts
TYPE
refrigerator
YEARS MADE
—
FILTER LOCATION
top-left of the fresh-food compartment in most French-door layouts, away from the door bins
FILTER SLOT
PureSource 2 (WF2CB) bay
REPLACE EVERY
Every 6 months
ALSO BRANDED AS
—
EI24RD65KS1 · Quick Facts
Filter locationtop-left of the fresh-food compartment in most French-door layouts, away from the door bins
Filter slotPureSource 2 (WF2CB) bay
Replace everyEvery 6 months
Typical installTwist or push — 5 minutes, no tools

Every cartridge that fits this model — pulled live from the catalogue:

✓

Verified fit for EI24RD65KS1. Cross-checked against Frigidaire service documentation — this model family uses the WF2CB bay with no chip or bypass restrictions.

EI24RD65KS1 specifics — where the filter actually lives

Finding the bay is the easy part — this chassis puts it top-left of the fresh-food compartment in most French-door layouts, away from the door bins, so expect to clear one shelf edge before you have working room. Mechanically it is a quarter-turn twist-in seat: one twist to release, one to lock; between them you are holding the entire service procedure.

Practical notes from the install forums: expect the first swap to take longer than the box suggests — aged o-rings grip — so budget ten minutes, not five. Decode the plate and the parts question answers itself: count on EI to place this unit among French-door builds; that placement carries the water-path geometry with it. Finish codes such as S1 change the look, not the plumbing — order the cartridge by model, ignore the finish letter.

EI vs EW — what the prefix tells you

EI or EW: the badge difference that does (and does not) change the filter order. French-door on the EI side, Wave-Touch Electrolux French-door on the EW side — the parts catalog runs the same cartridge across both. read the code as 24 cubic feet of capacity, which tells you the cartridge’s real workload between changes.

Swap it in 5 minutes

Installing the replacement water filter in the EI24RD65KS1
  • Twist the old cartridge a quarter turn counterclockwise and pull it straight down — keep a towel in reach for the dribble.
  • Fill the new cartridge with cold tap water so the chamber is not fighting an air pocket.
  • Offer the new cartridge to the bay, push up, and twist a quarter turn clockwise until the stop catches.
  • Run two gallons through the dispenser to flush carbon fines, then hold the filter-reset control until the status light clears.

What this filter takes out of your water

Old cartridge vs new — the difference a timely swap makes
What it targetsStandard that covers it
Chlorine taste & odorNSF/ANSI 42 — aesthetic effects
Particulates, Class INSF/ANSI 42 — fine sediment
LeadNSF/ANSI 53 — health effects
Cysts (cryptosporidium, giardia)NSF/ANSI 53 — microbial
PFOA & PFOSNSF/ANSI 53 (P473) — varies by cartridge

Coverage above lists what the standard addresses, not a performance claim for any specific cartridge — removal claims vary by certificate, so check the NSF listing for the exact part number you are buying.

EI24RD65KS1 filter questions

Clearing the filter status light on a Electrolux EI24RD65KS1?

Hold the filter-reset control a few seconds after the swap; the status light clears only with a seated cartridge, and the EI24RD65KS1 manual maps the control by panel type.

Does the Electrolux EI24RD65KS1 need a bypass plug when the filter is out?

Nothing to buy — the WF2CB housing closes without a cartridge; water runs unfiltered until the next one goes in.

Are off-brand filters safe for an Electrolux refrigerator?

Certified aftermarket cartridges are built to the same NSF test standards as the OEM part, and federal warranty law (Magnuson-Moss) protects your coverage when you use them.

Why is the OEM WF2CB cartridge so much more expensive?

Part of the OEM price is the badge and the distribution chain. Certified alternatives meet the same test standards at a lower unit price, especially in multi-packs.

How often should I replace the filter in my EI24RD65KS1?

Every six months or at the rated gallon capacity, whichever comes first — the WF2CB class cartridges all share that service interval.

Do I need to turn off the water supply to change it?

No — the bay is designed for a live swap. Expect a small dribble, keep a towel in reach, and flush a couple of gallons through the new cartridge before the first glass.

Every filter that fits your fridge

OEM WF2CB cartridge

This bay takes the OEM WF2CB. ClearFit verified-fit alternatives for this exact slot are being staged — every compatible option for your fridge is one lookup away.

Check every filter that fits →

This filter expires six months from today

Your HVAC filter is probably on a different cycle. Track them all in one place.

6

months until this filter should be replaced (200-gal rated life)

Free tool · tracks fridge + HVAC + whole-house · auto-refill optional

More models using this filter

refrigerator
refrigerator
refrigerator
refrigerator

Related guides

POPULAR GUIDE

How to change a Whirlpool refrigerator water filter

Every Filter 1–6 bay location — including the door-mounted bays on WRX models, with door-open angles and cap-release quirks. — read the guide →

POPULAR GUIDE

How to reset your Whirlpool filter light

Filter 1–6 indicator maps showing which key actually clears the light on your panel. — read the guide →

WATER PROBLEM GUIDE

Does your fridge filter remove fluoride?

What EDR1RXD1-class carbon blocks actually take out — and the systems that do remove fluoride. — read the guide →