EI23BC35KS3
Exact-Fit Model Guide

Water Filter for the Electrolux EI23BC35KS3 (WF2CB)

Your Frigidaire refrigerator takes the WF2CB slot. Below is every filter that fits — OEM and certified alternatives — with real prices.

✓ 100% compatible — no bypass plug needed

🔧 5-min push-in swap

🇺🇸 Ships from Indiana

EI23BC35KS3 · Quick Facts
TYPE
refrigerator
YEARS MADE
FILTER LOCATION
high on the fresh-food side in most French-door layouts — upper back or left wall
FILTER SLOT
PureSource 2 (WF2CB) bay
REPLACE EVERY
Every 6 months
ALSO BRANDED AS
EI23BC35KS3 · Quick Facts
Filter locationhigh on the fresh-food side in most French-door layouts — upper back or left wall
Filter slotPureSource 2 (WF2CB) bay
Replace everyEvery 6 months
Typical installTwist or push — 5 minutes, no tools

Every cartridge that fits this model — pulled live from the catalogue:

Verified fit for EI23BC35KS3. Cross-checked against Frigidaire service documentation — this model family uses the WF2CB bay with no chip or bypass restrictions.

EI23BC35KS3 specifics — where the filter actually lives

The EI23BC35KS3 carries its water filter high on the fresh-food side in most French-door layouts — upper back or left wall, the same estate every French-door refrigerator in this family uses. It is a twist-lock bay: one twist to release, one to lock; between them you are holding the entire service procedure.

The small print owners learn the hard way: the change light ignores the new cartridge until you reset it, and the first removal always takes more muscle than the manual implies. Decode the plate and the parts question answers itself: it usually places the machine in the French-door family, a strong hint at the cartridge line, the reset behavior, and the service documentation worth consulting. Finish codes such as S3 change the look, not the plumbing — order the cartridge by model, ignore the finish letter.

EI vs EW — what the prefix tells you

Prefix families here: EI against EW. The door count differs — French-door against Wave-Touch Electrolux French-door — but the bay and the cartridge order do not. read the code as 23 cubic feet of capacity, which tells you the cartridge’s real workload between changes.

Swap it in 5 minutes

  • Twist the old cartridge a quarter turn counterclockwise and pull it straight down — keep a towel in reach for the dribble.
  • Fill the new cartridge with cold tap water so the chamber is not fighting an air pocket.
  • Offer the new cartridge to the bay, push up, and twist a quarter turn clockwise until the stop catches.
  • Run two gallons through the dispenser to flush carbon fines, then hold the filter-reset control until the status light clears.

What this filter takes out of your water

What it targetsStandard that covers it
Chlorine taste & odorNSF/ANSI 42 — aesthetic effects
Particulates, Class INSF/ANSI 42 — fine sediment
LeadNSF/ANSI 53 — health effects
Cysts (cryptosporidium, giardia)NSF/ANSI 53 — microbial
PFOA & PFOSNSF/ANSI 53 (P473) — varies by cartridge

Coverage above lists what the standard addresses, not a performance claim for any specific cartridge — removal claims vary by certificate, so check the NSF listing for the exact part number you are buying.

EI23BC35KS3 filter questions

Clearing the filter status light on a Electrolux EI23BC35KS3?

Hold the filter-reset control a few seconds after seating the new cartridge; placements vary by control panel, and the EI23BC35KS3 manual’s filter-status page has the exact spot.

Can I run the Electrolux EI23BC35KS3 with no cartridge installed?

The bay self-seals: with no cartridge the EI23BC35KS3 still dispenses, just unfiltered. No bypass plug exists for this line.

Are off-brand filters safe for an Electrolux refrigerator?

Certified aftermarket cartridges are built to the same NSF test standards as the OEM part, and federal warranty law (Magnuson-Moss) protects your coverage when you use them.

Why is the OEM WF2CB cartridge so much more expensive?

Part of the OEM price is the badge and the distribution chain. Certified alternatives meet the same test standards at a lower unit price, especially in multi-packs.

How often should I replace the filter in my EI23BC35KS3?

Every six months or at the rated gallon capacity, whichever comes first — the WF2CB class cartridges all share that service interval.

Do I need to turn off the water supply to change it?

No — the bay is designed for a live swap. Expect a small dribble, keep a towel in reach, and flush a couple of gallons through the new cartridge before the first glass.

Every filter that fits your fridge

OEM WF2CB cartridge

This bay takes the OEM WF2CB. ClearFit verified-fit alternatives for this exact slot are being staged — every compatible option for your fridge is one lookup away.

Check every filter that fits →

This filter expires six months from today

Your HVAC filter is probably on a different cycle. Track them all in one place.

6

months until this filter should be replaced (200-gal rated life)

Free tool · tracks fridge + HVAC + whole-house · auto-refill optional

More models using this filter

refrigerator
refrigerator
refrigerator
refrigerator

Related guides

GUIDE · 4,400 SEARCHES/MO

How to change a Whirlpool refrigerator water filter

Every Filter 1–6 bay location — including the door-mounted bays on WRX models, with door-open angles and cap-release quirks. — read the guide →

GUIDE · 2,300 SEARCHES/MO

How to reset your Whirlpool filter light

Filter 1–6 indicator maps showing which key actually clears the light on your panel. — read the guide →

WATER PROBLEM · 27,100 SEARCHES/MO

Does your fridge filter remove fluoride?

What EDR1RXD1-class carbon blocks actually take out — and the systems that do remove fluoride. — read the guide →