CRSH232PS1
Exact-Fit Model Guide

Water Filter for the Crosley CRSH232PS1 (WF3CB)

Your Frigidaire refrigerator takes the WF3CB slot. Below is every filter that fits — OEM and certified alternatives — with real prices.

✓ 100% compatible — no bypass plug needed

🔧 5-min push-in swap

🇺🇸 Ships from Indiana

CRSH232PS1 replacement water filter cartridge
Replacement cartridge for this model
CRSH232PS1 · Quick Facts
TYPE
refrigerator
YEARS MADE
FILTER LOCATION
behind the lower fresh-food trim or base grille in most side-by-side layouts
FILTER SLOT
PureSource 3 (WF3CB) bay
REPLACE EVERY
Every 6 months
ALSO BRANDED AS
CRSH232PS1 · Quick Facts
Filter locationbehind the lower fresh-food trim or base grille in most side-by-side layouts
Filter slotPureSource 3 (WF3CB) bay
Replace everyEvery 6 months
Typical installTwist or push — 5 minutes, no tools

Every cartridge that fits this model — pulled live from the catalogue:

Verified fit for CRSH232PS1. Cross-checked against Frigidaire service documentation — this model family uses the WF3CB bay with no chip or bypass restrictions.

CRSH232PS1 specifics — where the filter actually lives

On the CRSH232PS1, the cartridge behind the lower fresh-food trim or base grille in most side-by-side layouts, the same estate every side-by-side refrigerator in this family uses. Mechanically the CRSH232PS1 uses a twist-in cartridge: one twist to release, one to lock; between them you are holding the entire service procedure.

Before you click buy, two things: the reset control is the step everyone skips; the light will not acknowledge a new cartridge on its own. CRSH reads as a chassis statement rather than a trim code: it usually marks a side-by-side layout, which means shared cartridge economics — one media family, dozens of cabinet variants, all drinking from the same parts line. The S1 tail marks finish variants of one chassis; the filter bay is shared across the entire finish range.

CRSH vs FFSS — what the prefix tells you

Catalog distance, parts proximity: CRSH/FFSS sit apart in the brochure, together in the parts catalog. read the code as 23 cubic feet of capacity, which tells you the cartridge’s real workload between changes.

Swap it in 5 minutes

Installing the replacement water filter in the CRSH232PS1
  • Twist the old cartridge a quarter turn counterclockwise and pull it straight down — keep a towel in reach for the dribble.
  • Fill the new cartridge with cold tap water so the chamber is not fighting an air pocket.
  • Offer the new cartridge to the bay, push up, and twist a quarter turn clockwise until the stop catches.
  • Run two gallons through the dispenser to flush carbon fines, then hold the filter-reset control until the status light clears.

What this filter takes out of your water

Old cartridge vs new — the difference a timely swap makes
What it targetsStandard that covers it
Chlorine taste & odorNSF/ANSI 42 — aesthetic effects
Particulates, Class INSF/ANSI 42 — fine sediment
LeadNSF/ANSI 53 — health effects
Cysts (cryptosporidium, giardia)NSF/ANSI 53 — microbial
PFOA & PFOSNSF/ANSI 53 (P473) — varies by cartridge

Coverage above lists what the standard addresses, not a performance claim for any specific cartridge — removal claims vary by certificate, so check the NSF listing for the exact part number you are buying.

CRSH232PS1 filter questions

Crosley CRSH232PS1: how do I clear the change-filter light?

With the new cartridge seated, press and hold the filter reset until the light clears — panel placement differs, so the CRSH232PS1 manual’s filter section has the exact control for your trim.

Is a bypass plug required for the CRSH232PS1 when the cartridge is removed?

Nothing to buy — the WF3CB housing closes without a cartridge; water runs unfiltered until the next one goes in.

Are off-brand filters safe for a Crosley refrigerator?

Certified aftermarket cartridges are built to the same NSF test standards as the OEM part, and federal warranty law (Magnuson-Moss) protects your coverage when you use them.

Why is the OEM WF3CB cartridge so much more expensive?

Part of the OEM price is the badge and the distribution chain. Certified alternatives meet the same test standards at a lower unit price, especially in multi-packs.

How often should I replace the filter in my CRSH232PS1?

Every six months or at the rated gallon capacity, whichever comes first — the WF3CB class cartridges all share that service interval.

Do I need to turn off the water supply to change it?

No — the bay is designed for a live swap. Expect a small dribble, keep a towel in reach, and flush a couple of gallons through the new cartridge before the first glass.

Every filter that fits your fridge

OEM WF3CB cartridge

This bay takes the OEM WF3CB. ClearFit verified-fit alternatives for this exact slot are being staged — every compatible option for your fridge is one lookup away.

Check every filter that fits →

This filter expires six months from today

Your HVAC filter is probably on a different cycle. Track them all in one place.

6

months until this filter should be replaced (200-gal rated life)

Free tool · tracks fridge + HVAC + whole-house · auto-refill optional

More models using this filter

refrigerator
refrigerator
refrigerator
refrigerator

Related guides

POPULAR GUIDE

How to change a Whirlpool refrigerator water filter

Every Filter 1–6 bay location — including the door-mounted bays on WRX models, with door-open angles and cap-release quirks. — read the guide →

POPULAR GUIDE

How to reset your Whirlpool filter light

Filter 1–6 indicator maps showing which key actually clears the light on your panel. — read the guide →

WATER PROBLEM GUIDE

Does your fridge filter remove fluoride?

What EDR1RXD1-class carbon blocks actually take out — and the systems that do remove fluoride. — read the guide →