Home › Refrigerator Water Filters › Whirlpool › MSD2550VES01
Water Filter for the Maytag MSD2550VES01 (EDR3RXD1)
✓ 100% compatible — no bypass plug needed
🔧 5-min push-in swap
🇺🇸 Ships from Indiana
Every cartridge that fits this model — pulled live from the catalogue:
✓
MSD2550VES01 specifics — where the filter actually lives
The MSD2550VES01 carries its water filter low on the fresh-food side or behind the base grille in most side-by-side layouts, a spot that survives trim changes across the MSD run. Mechanically the MSD2550VES01 uses a twist-in cartridge: one twist to release, one to lock; between them you are holding the entire service procedure.
The recurring owner notes: the reset control is the step everyone skips; the light will not acknowledge a new cartridge on its own. MSD reads as a chassis statement rather than a trim code: it usually places the machine in the side-by-side family, a strong hint at the cartridge line, the reset behavior, and the service documentation worth consulting. The two-digit 01 tail is revision bookkeeping. Badge position and shelf trim moved around; the bay geometry did not.
MSD vs MFI — what the prefix tells you
MSD versus MFI is the first fork in the parts catalog: Ordering by prefix works because MSD means side-by-side and MFI means French-door in this catalog — and the cartridge pool overlaps both. By model-code convention the MSD2550VES01 falls around 2008-2012; treat the dates as a working estimate, not record.
Swap it in 5 minutes
- Twist the old cartridge a quarter turn counterclockwise and pull it straight down — keep a towel in reach for the dribble.
- Fill the new cartridge with cold tap water so the chamber is not fighting an air pocket.
- Offer the new cartridge to the bay, push up, and twist a quarter turn clockwise until the stop catches.
- Run two gallons through the dispenser to flush carbon fines, then hold the filter-reset control until the status light clears.
What this filter takes out of your water
| What it targets | Standard that covers it |
|---|---|
| Chlorine taste & odor | NSF/ANSI 42 — aesthetic effects |
| Particulates, Class I | NSF/ANSI 42 — fine sediment |
| Lead | NSF/ANSI 53 — health effects |
| Cysts (cryptosporidium, giardia) | NSF/ANSI 53 — microbial |
| PFOA & PFOS | NSF/ANSI 53 (P473) — varies by cartridge |
Coverage above lists what the standard addresses, not a performance claim for any specific cartridge — removal claims vary by certificate, so check the NSF listing for the exact part number you are buying.
MSD2550VES01 filter questions
Maytag MSD2550VES01: how do I clear the change-filter light?
Hold the filter-reset control a few seconds after the swap; the status light clears only with a seated cartridge, and the MSD2550VES01 manual maps the control by panel type.
Can I run the Maytag MSD2550VES01 with no cartridge installed?
No — run it empty if you like; the EDR3RXD1 bay needs no bypass plug, it simply passes water through untreated.
Are off-brand filters safe for a Maytag refrigerator?
Certified aftermarket cartridges are built to the same NSF test standards as the OEM part, and federal warranty law (Magnuson-Moss) protects your coverage when you use them.
Why is the OEM EDR3RXD1 cartridge so much more expensive?
Part of the OEM price is the badge and the distribution chain. Certified alternatives meet the same test standards at a lower unit price, especially in multi-packs.
How often should I replace the filter in my MSD2550VES01?
Every six months or at the rated gallon capacity, whichever comes first — the EDR3RXD1 class cartridges all share that service interval.
Do I need to turn off the water supply to change it?
No — the bay is designed for a live swap. Expect a small dribble, keep a towel in reach, and flush a couple of gallons through the new cartridge before the first glass.
Every filter that fits your fridge
| Cartridge | OEM EDR3RXD1 | RECOMMENDEDEDR3RXD1 Replacement Water Filter · 1-Pack – ClearFit | EDR3RXD1 Replacement Water Filter · 3-Pack – ClearFit | EDR3RXD1 Replacement Water Filter · 6-Pack – ClearFit |
|---|---|---|---|---|
| Price | OEM list | $17.99 | $44.97 | $80.94 |
| Verified fit | ✓ the bay cartridge | View & buy → | View & buy → | View & buy → |
This filter expires six months from today
Your HVAC filter is probably on a different cycle. Track them all in one place.
months until this filter should be replaced (200-gal rated life)
Free tool · tracks fridge + HVAC + whole-house · auto-refill optional
More models using this filter
Related guides
POPULAR GUIDE
How to change a Whirlpool refrigerator water filter
Every Filter 1–6 bay location — including the door-mounted bays on WRX models, with door-open angles and cap-release quirks. — read the guide →
POPULAR GUIDE
How to reset your Whirlpool filter light
Filter 1–6 indicator maps showing which key actually clears the light on your panel. — read the guide →
WATER PROBLEM GUIDE
Does your fridge filter remove fluoride?
What EDR1RXD1-class carbon blocks actually take out — and the systems that do remove fluoride. — read the guide →