GHSC39ETJW0
Exact-Fit Model Guide

Water Filter for the Frigidaire GHSC39ETJW0 (WF2CB)

Your Frigidaire refrigerator takes the WF2CB slot. Below is every filter that fits — OEM and certified alternatives — with real prices.

✓ 100% compatible — no bypass plug needed

🔧 5-min push-in swap

🇺🇸 Ships from Indiana

GHSC39ETJW0 replacement water filter cartridge
Replacement cartridge for this model
GHSC39ETJW0 · Quick Facts
TYPE
refrigerator
YEARS MADE
—
FILTER LOCATION
bottom of the fresh-food column or at the grille line in most side-by-side builds
FILTER SLOT
PureSource 2 (WF2CB) bay
REPLACE EVERY
Every 6 months
ALSO BRANDED AS
—
GHSC39ETJW0 · Quick Facts
Filter locationbottom of the fresh-food column or at the grille line in most side-by-side builds
Filter slotPureSource 2 (WF2CB) bay
Replace everyEvery 6 months
Typical installTwist or push — 5 minutes, no tools

Every cartridge that fits this model — pulled live from the catalogue:

✓

Verified fit for GHSC39ETJW0. Cross-checked against Frigidaire service documentation — this model family uses the WF2CB bay with no chip or bypass restrictions.

GHSC39ETJW0 specifics — where the filter actually lives

The GHSC39ETJW0 carries its water filter bottom of the fresh-food column or at the grille line in most side-by-side builds, a spot that survives trim changes across the GHSC run. This is a twist-style bay, the friendlier design: one twist to release, one to lock; between them you are holding the entire service procedure.

Two quirks worth knowing before you order: the line is still live when you open the bay, so keep a towel in reach, and expect the filter-status light to need a reset before it believes the new cartridge. The GHSC in GHSC39ETJW0 is doing real work: it usually places the machine in the side-by-side family, a strong hint at the cartridge line, the reset behavior, and the service documentation worth consulting. The W0 tail marks finish variants of one chassis; the filter bay is shared across the entire finish range.

GHSC vs FFSS — what the prefix tells you

Know your GHSC from your FFSS and the cartridge question halves: The door count differs — side-by-side family against side-by-side — but the bay and the cartridge order do not. Cabinet decode: 39 cu ft — the number that tells you whether this cartridge feeds a family-size dispenser or a compact one.

Swap it in 5 minutes

Installing the replacement water filter in the GHSC39ETJW0
  • Twist the old cartridge a quarter turn counterclockwise and pull it straight down — keep a towel in reach for the dribble.
  • Fill the new cartridge with cold tap water so the chamber is not fighting an air pocket.
  • Offer the new cartridge to the bay, push up, and twist a quarter turn clockwise until the stop catches.
  • Run two gallons through the dispenser to flush carbon fines, then hold the filter-reset control until the status light clears.

What this filter takes out of your water

Old cartridge vs new — the difference a timely swap makes
What it targetsStandard that covers it
Chlorine taste & odorNSF/ANSI 42 — aesthetic effects
Particulates, Class INSF/ANSI 42 — fine sediment
LeadNSF/ANSI 53 — health effects
Cysts (cryptosporidium, giardia)NSF/ANSI 53 — microbial
PFOA & PFOSNSF/ANSI 53 (P473) — varies by cartridge

Coverage above lists what the standard addresses, not a performance claim for any specific cartridge — removal claims vary by certificate, so check the NSF listing for the exact part number you are buying.

GHSC39ETJW0 filter questions

Frigidaire GHSC39ETJW0: how do I clear the change-filter light?

Hold the filter-reset control a few seconds after seating the new cartridge; placements vary by control panel, and the GHSC39ETJW0 manual’s filter-status page has the exact spot.

GHSC39ETJW0 with no water filter installed — safe, or does it need a bypass?

Nothing to buy — the WF2CB housing closes without a cartridge; water runs unfiltered until the next one goes in.

Are off-brand filters safe for a Frigidaire refrigerator?

Certified aftermarket cartridges are built to the same NSF test standards as the OEM part, and federal warranty law (Magnuson-Moss) protects your coverage when you use them.

Why is the OEM WF2CB cartridge so much more expensive?

Part of the OEM price is the badge and the distribution chain. Certified alternatives meet the same test standards at a lower unit price, especially in multi-packs.

How often should I replace the filter in my GHSC39ETJW0?

Every six months or at the rated gallon capacity, whichever comes first — the WF2CB class cartridges all share that service interval.

Do I need to turn off the water supply to change it?

No — the bay is designed for a live swap. Expect a small dribble, keep a towel in reach, and flush a couple of gallons through the new cartridge before the first glass.

Every filter that fits your fridge

OEM WF2CB cartridge

This bay takes the OEM WF2CB. ClearFit verified-fit alternatives for this exact slot are being staged — every compatible option for your fridge is one lookup away.

Check every filter that fits →

This filter expires six months from today

Your HVAC filter is probably on a different cycle. Track them all in one place.

6

months until this filter should be replaced (200-gal rated life)

Free tool · tracks fridge + HVAC + whole-house · auto-refill optional

More models using this filter

refrigerator
refrigerator
refrigerator
refrigerator

Related guides

POPULAR GUIDE

How to change a Whirlpool refrigerator water filter

Every Filter 1–6 bay location — including the door-mounted bays on WRX models, with door-open angles and cap-release quirks. — read the guide →

POPULAR GUIDE

How to reset your Whirlpool filter light

Filter 1–6 indicator maps showing which key actually clears the light on your panel. — read the guide →

WATER PROBLEM GUIDE

Does your fridge filter remove fluoride?

What EDR1RXD1-class carbon blocks actually take out — and the systems that do remove fluoride. — read the guide →