HomeRefrigerator Water FiltersWhirlpoolVIKING-VCSF036D

VIKING-VCSF036D
Exact-Fit Model Guide

Water Filter for the Whirlpool VIKING-VCSF036D (EDR4RXD1)

Your Whirlpool refrigerator takes the EDR4RXD1 slot. Below is every filter that fits — OEM and certified alternatives — with real prices.

✓ 100% compatible — no bypass plug needed

🔧 5-min push-in swap

🇺🇸 Ships from Indiana

VIKING-VCSF036D replacement water filter cartridge
Replacement cartridge for this model
VIKING-VCSF036D · Quick Facts
TYPE
refrigerator
YEARS MADE
2008-2012
FILTER LOCATION
inside the fresh-food cavity, position varying with dispenser spec
FILTER SLOT
EveryDrop Filter 4 bay
REPLACE EVERY
Every 6 months
ALSO BRANDED AS
VIKING-VCSF036D · Quick Facts
Filter locationinside the fresh-food cavity, position varying with dispenser spec
Filter slotEveryDrop Filter 4 bay
Replace everyEvery 6 months
Years made2008-2012
Typical installTwist or push — 5 minutes, no tools

Every cartridge that fits this model — pulled live from the catalogue:

Verified fit for VIKING-VCSF036D. Cross-checked against Whirlpool service documentation — this model family uses the EDR4RXD1 bay with no chip or bypass restrictions.

VIKING-VCSF036D specifics — where the filter actually lives

The VIKING-VCSF036D carries its water filter inside the fresh-food cavity, position varying with dispenser spec, a spot that survives trim changes across the refrigerator run. It is a twist-lock bay: seat the cartridge against the o-ring, quarter-turn clockwise, and let the keyed flange do the aligning for you.

The recurring owner notes: carbon fines in the first pours are normal for a fresh bed, and the filter timer only restarts when you hold the reset. One more anchor for the parts search: this chassis drinks from the EDR4RXD1 family, one of the most cross-referenced cartridges in the Viking catalog. That 6D suffix is trim-level shorthand. Viking kept the EDR4RXD1 bay common to every finish in the line.

Reading the VIKING-VCSF036D model code — what the digits tell you

The VIKING-VCSF036D code suggests roughly 2008 to 2012 production — approximately right, which is all a parts search needs. What stays constant across the trim range: the EDR4RXD1 cartridge is the one constant across the model run.

Swap it in 5 minutes

Installing the replacement water filter in the VIKING-VCSF036D
  • Twist the old cartridge a quarter turn counterclockwise and pull it straight down — keep a towel in reach for the dribble.
  • Fill the new cartridge with cold tap water so the chamber is not fighting an air pocket.
  • Offer the new cartridge to the bay, push up, and twist a quarter turn clockwise until the stop catches.
  • Run two gallons through the dispenser to flush carbon fines, then hold the filter-reset control until the status light clears.

What this filter takes out of your water

Old cartridge vs new — the difference a timely swap makes
What it targetsStandard that covers it
Chlorine taste & odorNSF/ANSI 42 — aesthetic effects
Particulates, Class INSF/ANSI 42 — fine sediment
LeadNSF/ANSI 53 — health effects
Cysts (cryptosporidium, giardia)NSF/ANSI 53 — microbial
PFOA & PFOSNSF/ANSI 53 (P473) — varies by cartridge

Coverage above lists what the standard addresses, not a performance claim for any specific cartridge — removal claims vary by certificate, so check the NSF listing for the exact part number you are buying.

VIKING-VCSF036D filter questions

Clearing the filter status light on a Viking VIKING-VCSF036D?

Seat the new cartridge first, then hold the filter-reset control for a few seconds until the status light clears — the exact button placement varies by control panel, so check the VIKING-VCSF036D owner’s manual page for filter status.

Does the Viking VIKING-VCSF036D need a bypass plug when the filter is out?

The bay self-seals: with no cartridge the VIKING-VCSF036D still dispenses, just unfiltered. No bypass plug exists for this line.

Are off-brand filters safe for a Viking refrigerator?

Certified aftermarket cartridges are built to the same NSF test standards as the OEM part, and federal warranty law (Magnuson-Moss) protects your coverage when you use them.

Why is the OEM EDR4RXD1 cartridge so much more expensive?

Part of the OEM price is the badge and the distribution chain. Certified alternatives meet the same test standards at a lower unit price, especially in multi-packs.

How often should I replace the filter in my VIKING-VCSF036D?

Every six months or at the rated gallon capacity, whichever comes first — the EDR4RXD1 class cartridges all share that service interval.

Do I need to turn off the water supply to change it?

No — the bay is designed for a live swap. Expect a small dribble, keep a towel in reach, and flush a couple of gallons through the new cartridge before the first glass.

Every filter that fits your fridge

OEM EDR4RXD1 cartridge

This bay takes the OEM EDR4RXD1. ClearFit verified-fit alternatives for this exact slot are being staged — every compatible option for your fridge is one lookup away.

Check every filter that fits →

This filter expires six months from today

Your HVAC filter is probably on a different cycle. Track them all in one place.

6

months until this filter should be replaced (200-gal rated life)

Free tool · tracks fridge + HVAC + whole-house · auto-refill optional

More models using this filter

refrigerator
refrigerator
refrigerator
refrigerator

Related guides

POPULAR GUIDE

How to change a Whirlpool refrigerator water filter

Every Filter 1–6 bay location — including the door-mounted bays on WRX models, with door-open angles and cap-release quirks. — read the guide →

POPULAR GUIDE

How to reset your Whirlpool filter light

Filter 1–6 indicator maps showing which key actually clears the light on your panel. — read the guide →

WATER PROBLEM GUIDE

Does your fridge filter remove fluoride?

What EDR1RXD1-class carbon blocks actually take out — and the systems that do remove fluoride. — read the guide →